In this study, multifunctionality of graphitic carbon nitride quantum dots (g-C3N4 QDs) have been explored as a photovoltaic booster for polymer solar cell. Facile synthesis method of g-C3N4 QDs using organic solvent like o-dichlorobenzene which is commonly used for cell fabrication, has been demonstrated. Photovoltaic effect formation and various effects of QDs on energy transfer, carrier transport and nanoscale film morphology of the devices have been investigated thoroughly by incorporating g-C3N4 QDs as a third component into a well-established material combination of P3HT: PC71BM blend films. While systematic variation of device performances was observed with varying concentration of QDs, at an optimal concentration of 2%, almost 40% performance improvement was achieved compared to the pristine devices. The g-C3N4 QDs were found to assist Förster resonance energy transfer (FRET) between the QDs and host polymer, improving overall energy harvesting capability of the devices. The emission spectra of g-C3N4 QDs (λEms = 400–550) and absorption spectra of P3HT (λAbs = 400–600) were found to have overlapping features which enabled the QDs to transfer ultraviolet region photon energy to P3HT. The g-C3N4 QDs were also found to be favorable for maintaining nanoscale phase segregation of the active layer with improved crystallinity which is crucial for efficient exciton dissociation and faster charge extraction. The enhanced power conversion efficiency thus attributed to the combined consequences of improved morphology and FRET effect. This study opens new prospects for developing high-efficiency solution processable photovoltaic devices using g-C3N4 QDs as the third component of the active layer.
10 June 2021 in IEEE Transactions on Electron Devices
The distribution of trap states in the active layer of perovskite solar cells is a key limiting factor that largely controls the charge carrier mobility, rate of recombination of trapped charges, and, subsequently, the power conversion efficiency. In the present study, the charge carrier dynamics and the influences of the energetic distribution of trap states over device performance of nickel oxide based inverted perovskite solar cells have been investigated in detail by analyzing their temperature dependent transient photoresponses. The reduction in temperature during electrical measurement has induced anomalous behavior in current-voltage characteristics and distribution of trap states. The tail states energy of the valance band decreases from 150 to 50 meV as the temperature of the transient photocurrent measurement increases from 83 to 300 K. The applied bias significantly influences the shape and location of the density of states distribution, indicating their ionic origin. The transient photovoltage measurement revealed that the devices show rapid recombination of localized photogenerated charge carriers around the orthorhombic to the tetragonal phase transition region. The detailed study of trap state analysis and their various impacts on the device performances will prove beneficial for the fundamental understanding of the device physics, material design, and performance stabilization for perovskite solar cells and related devices.
The inclusion of plasmonic nanoparticles into organic solar cell enhances the light harvesting properties that lead to higher power conversion efficiency without altering the device configuration. This work defines the consequences of the nanoparticle overloading amount and energy transfer process between gold nanorod and polymer (active matrix) in organic solar cells. We have studied the hole population decay dynamics coupled with gold nanorods loading amount which provides better understanding about device performance limiting factors. The exciton and plasmon together act as an interacting dipole; however, the energy exchange between these two has been elucidated via plasmon resonance energy transfer (PRET) mechanism. Further, the charge species have been identified specifically with respect to their energy levels appearing in ultrafast time domain. The specific interaction of these charge species with respective surface plasmon resonance mode, i.e., exciton to transverse mode of oscillation and polaron pair to longitudinal mode of oscillations, has been explained. Thus, our analysis reveals that PRET enhances the carrier population density in polymer via non-radiative process beyond the concurrence of a particular plasmon resonance oscillation mode and polymer absorption range. These findings give new insight and reveal specifically the factors that enhance and control the performance of gold nanorods blended organic solar cells. This work would lead in the emergence of future plasmon based efficient organic electronic devices.
The quality performance analysis of any solar cell can only be predicted through the parameters extracted from its current-voltage characteristics. Herein, we demonstrate an efficient analytical method to calculate the series resistance of organic solar cells without any pre approximation. It has been shown that the inaccuracy in series resistance takes place due to the high ideality factor of the organic based solar cells, usually ranging from 2-5. Using a systemic approach, we solved the single diode solar cell model to determine the series resistance expression. The dependence of series resistance on ideality factor of the device and the reverse saturation current calculation through the illuminated current-voltage characteristics has been presented here for the first time. The entire method has been programmatically realized in MATLAB. The extracted parameters values have been compared to the other methods for the proof of validation and it shows good agreement where as some outputs are better resolved. Additionally, the effectiveness of the present method is also matched with NREL certified silicon solar cell (reference cell model 60623) parameter extracted from K24XX cell software provided with PET cell tester model, CT200AAA solar simulators. The present proposed method is not restricted to the organic solar cell only but it can also be applied for the other type of solar cell as well. Therefore, the proposed method shows the relevance in the present scenario of solar cell research and development.
In this manuscript, conventional and inverted organic solar cells based on P3HT:PC[60]BM have been explored to understand the effect of deep defect states on the open circuit voltage. The enhancement in the open circuit voltage in the inverted structure compared to the conventional structure has been comprehensively discussed in terms of density of defect states. To comply with the investigation, DC and AC measurements (impedance spectroscopy) at various temperatures have been performed extensively. Enhancement in open circuit voltage at low temperature is observed which is described by the shifting of hole and electron quasi-Fermi levels. The important observation from the defect density of states profile is that the center of Gaussian distribution is shifted to high energy as the temperature is increased which is an indication of the creation of shallow traps in polymers. In the inverted device, the disorder parameter (σ) is 33 meV, whereas in the conventional device it becomes 75 meV. This implies that the energetic disorder is reduced in an inverted device which helps in the improvement of open circuit voltage.