The proliferation of matrix converter interfaces coupled with traditional loads produces nonstandard and high-frequency harmonics in the range of (2 to 150) kHz in the power system. Although several research works have been conducted on passive and active filter solutions, most of these are low-frequency (below 2 kHz) solutions and are not effective under supraharmonic frequencies. An experimental study of a fuzzy-inference-system-controlled hybrid active power filter (HAPF) for the attenuation of higher frequency harmonics (above 8 kHz) is proposed. The compensational approach introduced is different from traditional approaches and the use of the fuzzy logic controller eliminates complexities involved in active filter designs. The proposed filter obtained a total harmonic distortion (THD) of 1.16% of the fundamental 50 Hz supply frequency. The performance of the proposed hybrid filter was compared with that of the proportional and integral (PI) controlled topology. The results obtained indicated superior performance of the fuzzy logic controller over the PI in terms of compensational speed, accuracy, the THD of the supply current and the overall integrity of the matrix converter. Illustrative design blocks and simulation in MATLAB/Simulink environment are provided to buttress these findings.

Hysteresis current controllers (HCCs) are extensively used in low-frequency power inverters and active power filters. Very little is known about their strengths and weaknesses when applied at supraharmonic frequencies. The major concern regarding the use of HCCs is their variable and uncontrollable switching frequencies. This results in difficulties in filter design, high switching losses, and the possibility of resonance conditions with power system elements. In this article, investigations are conducted on the application of HCCs in a hybrid filter for a 6 kHz matrix converter (MC)-coupled supraharmonic load. The effects of the MC-coupled load and VSC switches on the HCC’s switching frequency are analyzed. A novel mathematical model for obtaining a fixed-frequency HCC is presented. The model is verified in open- and closed-loop HCC control configurations for a three-phase hybrid active power filter (HAPF). Fast Fourier transform (FFT) analysis of the supply current after the implementation of the novel HCC-HAPF showed 2.31% of the 50 Hz fundamental. The analysis is verified in a MATLAB/Simulink environment.