Metal foam flow field suffers serious corrosion issues in proton exchange membrane fuel cells due to its large surface area. Ni and Ni/graphene coatings are prepared under constant and gradient current modes, respectively, to improve the corrosion resistance. The effect of the electrodeposition current mode and the deposition mechanism is studied. Compared with Ni coating, Ni/graphene coating brings low corrosion current density and high coating resistance, effectively enhancing the stability of Ni foam in an acidic environment. Different from Ni coating with a single layer, Ni/graphene deposits have core-shell structure, with graphene coated on the surface of Ni nanoparticles. It is shown that graphene deposits cover the Ni particles during the electrodeposition, which protects nickel particles from agglomeration and forms an inert film on the surface of the porous structure. After an 8 h constant potential test, no significant pitting is observed on the surface of Ni/graphene coating, showing excellent anticorrosion performance. As to the effect of the deposition current mode, it is shown that more composite particles deposit on the upper layer under the gradient current mode, which brings denser protective film and fewer surface defects on the surface. Ni/graphene coating electrodeposited under a gradient current mode between 0 and 10 mA·cm-2 exhibits the lowest corrosion current densities. The values at 50 and 80 °C are only 62.9 and 26.0% of those of uncoated Ni foam, respectively.
27 June 2016 in Industrial & Engineering Chemistry Research
The radial flow field structure, which has the advantages of low pressure drop, good water removal and good mass transfer, is an emerging structure for proton exchange membrane fuel cell (PEMFC) flow fields. However, optimization work on the design the structure is scarce for a complex structure that is difficult to manufacture. A comprehensive three-dimensional, non-isothermal and single-phase mathematical model is developed to describe the flow and heat, mass and charge transfer processes in a PEMFC. The transport phenomena and cell performance of radial flow fields with different gradient channels and parallel flow fields are studied and compared using the commercial computational fluid dynamics (CFD) software Fluent®. The distribution of oxygen concentration, pressure drop and temperature with different radial lengths is obtained. The effects of gradient channels, gas supply modes and radial lengths on cell performance are investigated. The results show that radial flow fields could offer more uniform oxygen distributions and lower pressure drops compared with parallel flow fields. Larger gradient channel sizes contribute to larger transfer volumes and higher gas molar concentrations in the catalyst layers and lower pressures in channels. The counter-flow supply mode is superior to the co-flow supply mode because it can enable a higher oxygen velocity and hence a higher current density.
1 January 2020 in Engineering Applications of Computational Fluid Mechanics
The emissions of volatile organic compounds (VOCs) from petroleum product tankers potentially represent a significant source of VOCs in port cities. Emission factors are used to estimate the produced VOCs. VOC emissions from transit operations were simulated using a two part model of heat and mass transfer. Using local meteorological data of air temperatures, solar radiation and wind speed, the heat transfer within the tank was modeled. Results showed that bulk cargo temperature remained relatively steady at 25–28°C, the oil surface oscillated diurnally by 1–2°C, and the deck temperature oscillates diurnally by 15–20°C. The solar insolation had the largest effect on the tank temperatures. VOC emissions for two crude oils and gasoline, two tank configurations, and two meteorological conditions were estimated using a model derived from a mass balance on the tank and the obtained temperature profile. Only 3 of 8 scenarios had pressure increases large enough to cause venting of VOC. C2-C5 compounds constituted the majority of VOCs released from crude oils and ethanol made up the majority of the VOCs released from the gasoline carrying barge. The calculated daily emission factors for crude oil and gasoline (barge) were 10 mg/L/day and 135 mg/L/day respectively.