High penetrations of photovoltaic (PV) systems can cause severe voltage quality problems in distribution networks. This paper proposes a distributed control strategy based on the dynamic formation of coalitions to coordinate a large number of PV inverters for voltage regulation. In this strategy, a rule-based coalition formation scheme deals with the zonal voltage difference caused by the uneven integration of PV capacity. Under this scheme, PV inverters form into separate voltage regulation coalitions autonomously according to local, neighbor as well as coalition voltage magnitude and regulation capacity information. To coordinate control within each coalition, we develop a feedback-based leader-follower consensus algorithm which eliminates the voltage violations caused by the fast fluctuations of load and PV generation. This algorithm allocates the required reactive power contribution among the PV inverters according to their maximum available capacity to promote an effective and fair use of the overall voltage regulation capacity. Case studies based on realistic distribution networks and field-recorded data validate the effectiveness of the proposed control strategy. Moreover, comparison with a centralized network decomposition-based scheme shows the flexibility of coalition formation in organizing the distributed PV inverters. The robustness and generalizability of the proposed strategy are also demonstrated.
11 January 2022 in IEEE Transactions on Power Systems
Optimal Volt/VAR control (VVC) in distribution networks relies on an effective coordination between the conventional utility-owned mechanical devices and the smart residential photovoltaic (PV) inverters. Typically, a central controller carries out a periodic optimization and sends setpoints to the local controller of each device. However, instead of tracking centrally dispatched setpoints, smart PV inverters can cooperate on a much faster timescale to reach optimality within a PV inverter group. To accommodate such PV inverter groups in the VVC architecture, this paper proposes a bi-level optimization framework. The upper-level determines the setpoints of the mechanical devices to minimize the network active power losses, while the lower-level represents the coordinated actions that the inverters take for their own objectives. The interactions between these two levels are captured in the bi-level optimization, which is solved using the Karush-Kuhn-Tucker (KKT) conditions. This framework fully exploits the capabilities of the different types of voltage regulation devices and enables them to cooperatively optimize their goals. Case studies on typical distribution networks with field-recorded data demonstrate the effectiveness and advantages of the proposed approach.
28 June 2018 in IEEE Transactions on Automatic Control
In networked control systems, selecting a subset of input and output nodes is a crucial step in designing a stabilizing controller. Most existing approaches to input and output selection focus on nominal systems with known parameters. For systems with uncertainties and time delays, current selection methods are based on exploiting the convexity after relaxing the original problem, which is inherently discrete, to continuous optimization forms, and hence lack optimality guarantees. This paper studies the problem of identifying the minimum-size sets of input and output nodes to guarantee stability of a linear system with uncertainties and time delays. We derive sufficient conditions to guarantee the existence of a stabilizing controller for an uncertain linear system, based on a subset of system modes lying within the controllability and observability subspaces induced by the selected inputs and outputs. We then formulate the problems of selecting minimum-size sets of input and output nodes to satisfy the derived conditions, and prove that they are equivalent to discrete optimization problems with bounded submodularity ratios. We develop polynomial-time selection algorithms with provable guarantees on the minimum number of inputs and outputs required. Our approach is applicable to various types of uncertainties, including additive uncertainty, multiplicative uncertainty, uncertain output delay, and structured uncertainty. In a numerical study, we test our approach for the wide-area damping control in power systems to ensure small signal stability. Our results are validated on the IEEE 39-bus test power system.
1 March 2010 in International Journal of Computer Mathematics
In this paper, the (n+1)-dimensional sine-Gordon equation is studied using double elliptic equation method. With the aid of Maple, more exact solutions expressed by Jacobi elliptic functions are obtained. When the modulus m of Jacobi elliptic function is driven to the limit 1 and 0, some exact solutions expressed by hyperbolic function solutions and trigonometric functions can also be obtained, respectively.