The ability to control and manipulate biological fluids within microchannels is a fundamental challenge in biological diagnosis and pharmaceutical analyses, particularly when buffers with very high ionic strength are used. In this study, we investigate the numerical and experimental study of fluidic biochips driven by ac electrothermal flow for controlling and manipulating biological samples inside a microchannel, e.g., for fluid-driven and manipulation purposes such as concentrating and mixing. By appropriately switching the voltage on the electrode structures and inducing AC electrothermal forces within the channel, a fluidic network with pumping and manipulation capabilities can be achieved, enabling the control of fluid velocity/direction and also fluid rotation. By using finite element analysis, coupled physics of electrical, thermal, fluidic fields, and molecular diffusion transport were solved. AC electrothermal flow was studied for pumping and mixing applications, and the optimal model was extracted. The microfluidic chip was fabricated using two processes: electrode structure development on the chip and silicon mold fabrication in a cleanroom. PDMS was prepared as the microchannel material and bonded to the electrode structure. After implementing the chip holder and excitation circuit, a biological buffer with varying ionic strengths (0.2, 0.4, and 0.6 [S/m]) was prepared, mixed with fluorescent particles, and loaded into the microfluidic chip. Experimental results demonstrated the efficiency of the proposed chip for biological applications, showing that stronger flows were generated with increasing fluid conductivity and excitation voltage. The system behavior was characterized using an impedance analyzer. Frequency response analysis revealed that for a solution with an electrical conductivity of 0.6 [S/m], the fluid velocity remained almost constant within a frequency range of 100 kHz to 10 MHz. Overall, the experimental results showed good agreement with the simulation outcomes.
Mercury detection is essential for ensuring the safety and environmental responsibility of clean energy technologies. This sensor can be used to detect mercury in water sources to remove the toxic pollutant from water effectively. Our proposed sensor addresses this demand by accurately detecting mercury ions through its mass-sensitive properties. The novelty of this sensor stems from two key aspects: first, the incorporation of a highly mercury-sensitive gold layer on the active area to enhance its capabilities and specificity to mercury ions; and second, its unique integration with a digital microfluidic system without any pump and microchannel. This system is fully compatible with microelectromechanical systems (MEMS) technology and can be used in conjunction with, or as part of, clean energy systems. This integration is crucial as it facilitates the delivery of deionized water droplets containing mercury ions to the sensing area. The sensor employs comb-drive electrodes to actuate its resonator in an in-plane mode, which causes its surfaces to slide parallel to the liquid interface. This leads to the mass and stiffness changes in the central resonator and consequently, a measurable frequency shift. Finite element analysis of the mechanical behavior of the sensor demonstrated a quality factor of 651 at a resonance frequency of 351.96 kHz for the resonator. Furthermore, the sensor exhibits a high sensitivity of approximately 105 Hz/ppb, highlighting its potential for trace mercury detection.