In this paper, a review of the Lagrangian stochastic models developed in the last decades for the simulation of the concentration–fluctuation dispersion is presented. The main approaches available in the literature are described and their ability in reproducing the higher order moments of the probability density function is discussed. Then, the Lagrangian approaches for evaluating of the odor annoyance are presented. It is worth to notice that, while Lagrangian stochastic models for mean concentrations are well-known and their ability in correctly reproducing the observation is well assessed, concerning concentration fluctuations the approaches are often new and unknown for most of the scientific community.
Halo-Photonics StreamLine XR Doppler LiDAR measurements are performed using several scan configurations (Velocity Azimuth Display-VAD and Doppler Beam Swing-DBS) and elevation angles of 60° and 80°. The measurements are compared to wind observations conducted by various in situ instruments (tethered balloon, meteorological mast, and radiosondes). Good agreement is obtained, with R2 over 0.90 for wind speed and a standard error ≤ 18.6° for wind direction. The best performance was attained for lower elevation scans (60°), which is consistent with the higher spatial horizontal homogeneity exhibited by lower angle scans. VAD and DBS scans performed almost equally well with slight advantage for VAD in higher altitudes and for DBS for lower altitudes. The boundary layer structure along a diurnal cycle is analyzed by utilizing retrieved backscatter data and wind measurements in conjunction with Weather Research and Forecast (WRF) simulations. The presence of multiple inversions which allow the coexistence of different layers within the studied profile is also verified using data acquired by several radiosondes. Synergic use of LiDAR data with WRF simulations for low SNR regions is demonstrated.
Simple plastic face shields have many advantages compared to regular medical masks. They are easily cleaned for reuse and comfortable to wear. In light of the spreading COVID-19 pandemic, the potential of face shields as a substitution for medical masks, as a recommendation to the general population, was tested. Testing the efficacy of the protective equipment utilized a cough simulator that was carefully tuned to replicate human cough in terms of droplet size distribution and outlet velocity. The tested protective equipment was worn on a manikin head simulating human breathing. An Aerodynamic Particle Sizer (APS) was used to analyze the concentration and size distribution of small particles that reach the manikin head respiration pathways. Additionally, Water sensitive papers were taped over and under the tested protective equipment, and were subsequently photographed and analyzed. For droplets larger than 3μm by diameter, the efficiency of shields to block cough droplets was found to be comparable to that of regular medical masks, with enhanced protection on face parts the mask does not cover. Additionally, for finer particles, of the order 0.3 to few microns, a shield was found to perform even better, blocking about 10 times more fine particles than the medical mask. This implies that for the general population that is not intendedly exposed to confirmed infected individuals, recommending the use of face shields as an alternative to medical masks should be considered.
Low-elevation Doppler wind lidar scans, known as arc scans, extend traditional vertical-profile measurements to horizontal, off-site locations. This technique is designed to enable measurements at multiple distant locations relative to the instrument. Arc-scan methods have been widely utilized in wind energy applications and are also a promising tool for environmental monitoring for hazard assessment. This method introduces specific challenges absent in traditional vertical profile scans. The limited scan angle restricts the number of wind orientations available for reliable vector extraction. A reliable method of estimating the uncertainty intervals for retrieved wind speed and direction in operational configurations is thus of interest. Here, we developed a closed-form statistical expression for evaluating wind speed and direction prediction intervals. Because rapid-update operational scenarios (such as real-time dispersion modeling) yield a limited number of scans, the framework is specifically designed to remain mathematically robust and computable using only diagonal variance terms, bypassing the need for numerically unstable cross-covariance matrices. The expression was tested against a lidar and sonic anemometry measurement campaign. The wind-arc alignment emerges as a major influencing parameter impacting uncertainty of both direction and speed retrievals. Conclusions regarding scan parameters and siting considerations are drawn.