Jinjun Ding

Dr. Jinjun Ding

Google LLC, Mountain View, CA, USA
orcid

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 July 2020 in Physical Review Applied
Verified
Journal Article
Closed access
PDF file
Jinjun DingJinjun Ding
Jinjun Ding
CLChuanpu Liu
Chuanpu Liu
YZYuejie Zhang
Yuejie Zhang
UEUppalaiah Erugu
Uppalaiah Erugu
ZQZhiyong Quan
Zhiyong Quan
MWMingzhong Wu
Mingzhong Wu
Y3Fe5O12 (YIG) thin films having a thickness of several nanometers and showing both strong perpendicular magnetic anisotropy (PMA) and low magnetic damping are reported. The films are deposited by magnetron sputtering at room temperature first and then annealed in O2 at high temperature. The substrates are Gd3(Sc2Ga3)O12, which share the same crystalline structure as YIG, but have a lattice constant slightly larger than that of YIG; the lattice mismatching gives rise to an out-of-plane compressive strain and PMA in the YIG films. The PMA is confirmed by vibrating sample magnetometer, magneto-optical Kerr effect, anomalous Hall effect, and angle-dependent ferromagnetic resonance (FMR) measurements. The damping of the films is analyzed through frequency-dependent FMR measurements. As an example, an 8-nm-thick YIG film shows an effective PMA field of about 2800 Oe, a nearly square hysteresis loop, and a damping constant of only 4.2×10−4. As an illustration of possible applications of such films in spintronic devices, current-induced switching of the magnetization of the PMA YIG films is demonstrated by the use of YIG/Pt bilayered Hall bar devices.

22 April 2020 in IEEE Magnetics Letters
Verified
Journal Article
Closed access
Jinjun DingJinjun Ding
Jinjun Ding
TLTao Liu
Tao Liu
HCHouchen Chang
Houchen Chang
MWMingzhong Wu
Mingzhong Wu
This letter reports the development of low-damping yttrium iron garnet (YIG) thin films via sputtering. The films were deposited by sputtering at room temperature first and were then annealed in O $_2$ at high temperature. It is found that the annealing temperature critically affects the structural properties of the YIG films and thereby dictates the static and dynamic properties of the films. A 75-nm-thick YIG film annealed at 900 °C shows a rms surface roughness of 0.08 nm, a coercivity of only 14 A/m (or 0.18 Oe), a saturation induction of 0.1778 T (or 1778 G) which is very close to the bulk value, a gyromagnetic ratio of 2.82×10 $-4$ MHz/T (or 2.82 MHz/Oe) which almost matches the standard value, and a Gilbert damping constant of α ∽ 5.2×10 $_5$ which is the lowest among the values reported so far for magnetic films in the nanometer thickness range. Frequency-dependent ferromagnetic resonance measurements with different field orientations confirmed that two-magnon scattering, if present, is very weak, and the measured damping value represents the actual damping of the YIG film.

7 April 2017 in Science Advances
Verified
Journal Article
Open access
PDF file
HCHouchen Chang
Houchen Chang
PJP. A. Praveen Janantha
P. A. Praveen Janantha
Jinjun DingJinjun Ding
Jinjun Ding
TLTao Liu
Tao Liu
KCKevin Cline
Kevin Cline
MWMingzhong Wu
Mingzhong Wu
The role of damping in the spin Seebeck effect (SSE) was studied experimentally for the first time. The experiments used Y3Fe5O12 (YIG)/Pt bilayered structures where the YIG films exhibit very similar structural and static magnetic properties but very different damping. The data show that a decrease in the damping gives rise to an increase in the SSE coefficient, which is qualitatively consistent with some of the theoretical models. This response also shows quasi-linear behavior, which was not predicted explicitly by previous studies. The data also indicate that the SSE coefficient shows no notable correlations with the enhanced damping due to spin pumping, which can be understood in the frame of two existing models.

3 May 2021 in Advanced Materials
Verified
Journal Article
Closed access
PDF file
Jinjun DingJinjun Ding
Jinjun Ding
CLChuanpu Liu
Chuanpu Liu
VKVijaysankar Kalappattil
Vijaysankar Kalappattil
YZYuejie Zhang
Yuejie Zhang
OMOleksandr Mosendz
Oleksandr Mosendz
MWMingzhong Wu
Mingzhong Wu

20 January 2021 in Advanced Functional Materials
Verified
Journal Article
Closed access
PDF file
Jinjun DingJinjun Ding
Jinjun Ding
CLChuanpu Liu
Chuanpu Liu
YZYuejie Zhang
Yuejie Zhang
VKVijaysankar Kalappattil
Vijaysankar Kalappattil
RYRui Yu
Rui Yu
MWMingzhong Wu
Mingzhong Wu

12 January 2021 in Physical Review B
Verified
Journal Article
Closed access
PDF file
JCJun Cheng
Jun Cheng
KHKang He
Kang He
MYMan Yang
Man Yang
QLQi Liu
Qi Liu
RYRui Yu
Rui Yu
HDH. F. Ding
H. F. Ding
Spin pumping is a technique widely used to generate pure spin current and characterize the spin-charge conversion efficiency of heavy metals. Upon microwave excitation, the sample may also be heated, and the parasitic thermoelectric signals could contaminate the spin pumping results. Owing to their identical angular dependences with respect to the magnetic field, it is difficult to isolate one from the other. In this paper, we present a quantitative method to separate thermoelectric contributions from spin pumping signals in both Py(Ni80Fe20)/Pt and YIG(Y3Fe5O12)/Pt bilayers through microwave photoresistance measurements. We find that the microwave absorption indeed can raise the temperature of samples, resulting a field-dependent thermoelectric hysteresis loop. However, the additional heat dissipation due to the resonant precession of the magnetization in the ferromagnet is negligibly small compared with the measured spin pumping signal. Thus, we conclude that the spin pumping signal is free of any detectable thermoelectric contributions.