When Langmuir-Blodgett (LB) films made of multilayered stearic acid or hematoporphyrin containing a phenol-red dye were exposed to a moist environment, changes in the absorption coefficient occurred. This is due to an ionization reaction of the dye molecules dispersed into these LB films. The optical humidity sensors which were simply constructed using these dye-adsorbed LB films operated with good reproducibility and a very fast response time.
Humidity measurement is required in various fields. We previously developed a sensor that leverages the sudden change in the transmitted light intensity when switching from leakage mode to waveguide mode. By adjusting the low-refractive-index polymer of the cladding, we achieved measurements at 60% RH. However, for practical use, measurements at low humidity are essential. Therefore, in this study, we developed a sensor using a leakage mode that enables measurements at low humidity. To measure the leakage mode, it is necessary to increase the absorbance of the cladding and the incident angle at the core–cladding interface. Therefore, we developed a sensor in which the core was stretched, and the cladding was doped with a high concentration of dye. The experimental results confirmed that a sensor with a polymer concentration of 4% and a dye concentration of 3% could measure from 0% RH to 95% RH. The sensitivity was 0.1 dB/% RH from 0% RH to 70% RH and 0.32 dB/% RH from 70% RH to 95% RH. The estimated response time for a change from 10% to 90% light transmission for a sensor with 4% polymer concentration and 0.5% dye concentration was 22 s from 45% RH to 0% RH and 50 s from 0% RH to 45% RH.
Because humidity is an important indicator used in many fields, the development of technology for its measurement is of great significance. We investigated humidity sensors that use a swellable polymer as the cladding material of plastic optical fibers. A plastic optical fiber humidity sensor using hydroxyethylcellulose as the cladding material has a linear response at approximately 20% relative humidity, but its sensitivity is low. The sensitivity can be improved by adding brilliant blue as a dye to the cladding. However, this makes the detection range of the sensor too narrow for practical use. Therefore, we change the incident light from a single wavelength to two wavelengths and use the fact that the output waveform of the dye-doped sensor depends on the wavelength of the incident light. The results of experiments show that a humidity sensor with high sensitivity and a relative-humidity detection range of 10–90% can be developed by combining the output waveforms of a two-wavelength sensor with a dye doping level of 0.8% in the cladding.
A basic operation of the very simple optical sensing system of fuel leakage in uniform sandy and clayey soils, which is consisting of a plastic optical fibre (POF) transmission line, the POF-type sensor heads, and a single LED photodiode pair, has been studied theoretically and experimentally. Its sensing principle is based on the POF structure change in the sensor head caused by fuels such as petrol. A scale-downed model prepared in the experimental room showed a possibility of optical detection of fuel leakage points in uniform soil. As this system operates without receiving the influence of water containing in fuels and soils, its application to fuel leak monitor around a filling station and oil tank can be expected.
1 January 2005 in IEEJ Transactions on Sensors and Micromachines