Liezhao Luo

Mr. Liezhao Luo

orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 September 2022 in Sensors
Verified
Journal Article
Open access
PDF file
LLLiezhao Luo
Liezhao Luo
Ting LiTing Li
Ting Li
JDJiangge Deng
Jiangge Deng
RZRunzhou Zhao
Runzhou Zhao
JWJinkui Wang
Jinkui Wang
This paper proposes an improved wavelength modulation spectroscopy with the 2nd harmonics normalized by the 1st harmonics (WMS-2f/1f) spectral fitting method using the orthogonal test in selection of the initial parameters. The method is implemented and validated experimentally in measurement of the temperature of diluted H2O in air (1 atm, 291K, 0.7%) by the WMS-2f/1f technique. The transition center wavelength targets near 1344 nm. Results demonstrate that the sum-square-error (SSE) between the calculated and measured WMS-2f/1f spectral profiles decreases significantly within given updating times when the optimized initial parameters are used. Compared to the conventional method, the optimized initial parameters can make the fitting routine converge more efficiently. The temperature of the vapor inferred from the proposed spectral fitting method are in good agreement with the true values.

11 August 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
LLLiezhao Luo
Liezhao Luo
Ting LiTing Li
Ting Li
JDJiangge Deng
Jiangge Deng
RZRunzhou Zhao
Runzhou Zhao
JWJinkui Wang
Jinkui Wang
LXLijun Xu
Lijun Xu
The experimental investigations into the thermoacoustic instability in a Rijke tube are presented. In order to capture the dynamics of the temperature, a single-ended tunable diode laser absorption spectroscopy (TDLAS) technique was developed, with a measurement rate of 5 kHz. The temperature was found to fluctuate periodically at a dominant frequency of 230 Hz, corresponding to the fundamental frequency of the Rijke tube used in the experiment. The flame chemiluminescence was detected by a high-speed camera to demonstrate flame response to thermoacoustic instability. It was evident that the flame front stretched regularly and had jagged edges. To quantitate the fluctuations of chemiluminescence intensity, the relative area was defined. According to the result, the intensity also oscillated at 230 Hz. Furthermore, the same feature was found in regard to pressure at the exit of the Rijke tube. Compared with temperature and chemiluminescent intensity, the pressure oscillations presented the most approximate standard waveform, as they suffered the least disruptions. The results indicated that the dominant frequencies of temperature, chemiluminescent intensity and pressure were consistent, in accordance with the fundamental frequency of the Rijke tube in the experiment. In addition, etalon effects on the TDLAS signals were mitigated efficiently by a lowpass filter.