Ting Li

Dr. Ting Li

School of Energy and Power Engineering, Beihang University, Beijing 100191, China

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 September 2022 in Sensors
Verified
Journal Article
Open access
PDF file
LLLiezhao Luo
Liezhao Luo
Ting LiTing Li
Ting Li
JDJiangge Deng
Jiangge Deng
RZRunzhou Zhao
Runzhou Zhao
JWJinkui Wang
Jinkui Wang
This paper proposes an improved wavelength modulation spectroscopy with the 2nd harmonics normalized by the 1st harmonics (WMS-2f/1f) spectral fitting method using the orthogonal test in selection of the initial parameters. The method is implemented and validated experimentally in measurement of the temperature of diluted H2O in air (1 atm, 291K, 0.7%) by the WMS-2f/1f technique. The transition center wavelength targets near 1344 nm. Results demonstrate that the sum-square-error (SSE) between the calculated and measured WMS-2f/1f spectral profiles decreases significantly within given updating times when the optimized initial parameters are used. Compared to the conventional method, the optimized initial parameters can make the fitting routine converge more efficiently. The temperature of the vapor inferred from the proposed spectral fitting method are in good agreement with the true values.

16 January 2020 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
MZMingxuan Zhang
Mingxuan Zhang
Jingxuan LiJingxuan Li
Jingxuan Li
WCWenwang Cheng
Wenwang Cheng
Ting LiTing Li
Ting Li
The thermoacoustic instability produced in a simple heat-driven-acoustic-oscillation device (so-called Rijke tube) has been controlled by the periodic plasma discharge. A perforated plate is placed at the upstream of the tube as the heater. Due to the interaction between the heat and acoustic waves, thermoacoustic instabilities occur. The high-voltage microsecond pulsed plasma is generated within pin-to-pin electrodes that are used as an actuator since the pressure wave generated by the plasma is quite strong and able to attenuate the thermoacoustic sound wave in the Rijke tube. However, since the pressure waveform generated by the plasma discharge is different from the sinusoidal signal that is generated by a loudspeaker and widely used as a control actuator, it is necessary to derive the new model from the simplified Rijke tube. The time domain oscillation simulation is conducted, and the phase shift method is used to find appropriate control strategy. The discharge pressure waveform is subsequently fitted with an eighth-order Fourier series, and the overall Fourier signal is adjusted so that the first-order waveform in the discharge was similar to the analog sinusoidal control signal; the control is quite effective. It is known that when the sinusoidal control waveform of same frequency as thermoacoustic instability can meet control requirements, the non-sinusoidal signal can also control the thermoacoustic instability. Finally, according to the simulation results, the high-voltage microsecond plasma discharge is adjusted to the suitable amplitude and phase used for closed-loop control on the thermoacoustic oscillation, which significantly suppressed the instability.

18 April 2018 in The Canadian Journal of Chemical Engineering
Verified
Journal Article
Closed access
PDF file
QEQitai Eri
Qitai Eri
BWBaolu Wang
Baolu Wang
JPJing Peng
Jing Peng
XZXinjun Zhao
Xinjun Zhao
Ting LiTing Li
Ting Li

11 August 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
LLLiezhao Luo
Liezhao Luo
Ting LiTing Li
Ting Li
JDJiangge Deng
Jiangge Deng
RZRunzhou Zhao
Runzhou Zhao
JWJinkui Wang
Jinkui Wang
LXLijun Xu
Lijun Xu
The experimental investigations into the thermoacoustic instability in a Rijke tube are presented. In order to capture the dynamics of the temperature, a single-ended tunable diode laser absorption spectroscopy (TDLAS) technique was developed, with a measurement rate of 5 kHz. The temperature was found to fluctuate periodically at a dominant frequency of 230 Hz, corresponding to the fundamental frequency of the Rijke tube used in the experiment. The flame chemiluminescence was detected by a high-speed camera to demonstrate flame response to thermoacoustic instability. It was evident that the flame front stretched regularly and had jagged edges. To quantitate the fluctuations of chemiluminescence intensity, the relative area was defined. According to the result, the intensity also oscillated at 230 Hz. Furthermore, the same feature was found in regard to pressure at the exit of the Rijke tube. Compared with temperature and chemiluminescent intensity, the pressure oscillations presented the most approximate standard waveform, as they suffered the least disruptions. The results indicated that the dominant frequencies of temperature, chemiluminescent intensity and pressure were consistent, in accordance with the fundamental frequency of the Rijke tube in the experiment. In addition, etalon effects on the TDLAS signals were mitigated efficiently by a lowpass filter.

16 December 2022 in Aerospace
Verified
Journal Article
Open access
PDF file
JDJiangge Deng
Jiangge Deng
Ting LiTing Li
Ting Li
JWJinkui Wang
Jinkui Wang
CGChicheng Gao
Chicheng Gao
Thermoacoustic instabilities occur when heat release is coupled with pressure fluctuation, which may cause performance degradation of the combustor and serious structural damage. This study focued on an active control method using discharge plasma and showed experimentally that discharge plasma can make a difference in controlling the thermoacoustic instabilities in a Rijke tube. A vertically placed Rijke tube thermoacoustic system using induction heating tungsten mesh as a heat source was built. The results show that the high repetition rate discharge can effectively suppress the thermoacoustic oscillations in the Rijke tube and that they will not re-occur for some time. Additionally, their effectiveness depended more on average power than energy per pulse. Combining the collected pressure, schlieren data, and theoretical analysis, it can be suggested that the plasma discharge could heat the inlet airflow, which could influence the heat exchange and then could break thermo-acoustic coupling, and its high-frequency pressure perturbation might increase the dissipation of the energy of sound.

8 September 2017 in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
Verified
Journal Article
Closed access
QEQitai Eri
Qitai Eri
ZZZhen Zhang
Zhen Zhang
RZRubing Zhang
Rubing Zhang
Ting LiTing Li
Ting Li
The effect of rectangular control jet on the mixing of round jet with ambient air was studied numerically, in the present work. The effect on the length of main jet potential core and the penetration depth of the control jet, due to variations in velocity and width of the control jet, was studied. The mechanism of jet mixing enhancement was also studied. The results indicated that due to the rectangle jets, the main core region was bifurcated. Thus, there were two definitions for the length of main jet core: the length of centerline potential core and the length of actual potential core. Both lengths decreased with increase in control jet velocity. Besides, the length of the actual potential core decreased with increase in control jet width. However, for the length of centerline potential core, there was a specific width, at which the length of centerline potential core reached a minimum value. Finally, the deformation of the main jet was a factor, more critical compared to the streamwise vortices, which had an effect on the control jet.