A large number of joint friction pairs work during the work of scroll compressors, resulting in high energy consumption and short service life of scroll compressors. To improve the tribological performance of friction pairs of the scroll compressors, the C-MoS2-PTFE (Polytetrafluoroethylene) lubrication coating is prepared through spraying technology on the surface of 4032 aluminum alloy, a common material for scroll compressors. The microstructure of the C-MoS2-PTFE coating was analyzed by X-ray diffractometer (XRD) and scanning electron microscope (SEM), and the wear behavior of the coating under different loads was studied by reciprocating friction and wear testing machine and three-dimensional profiler. The surface of the grinding marks was analyzed by SEM and energy density spectrum (EDS). The performance was compared with the anodized film of 4032 aluminum alloy and the Ni-coated coating of 4032 aluminum alloy. The experimental results show that the C-MoS2-PTFE coating has a dense structure, and the hardness is 35 HV0.1. Under dry friction conditions, the C-MoS2-PTFE coating has excellent wear reduction and wear resistance, and the coefficient of friction and wears rate under different loads are less than those of the anodized film of 4032 aluminum alloy and the Ni-plated coating. The wear mechanisms of C-MoS2-PTFE coating are fatigue wear, adhesive wear, abrasive wear, and oxidation wear under different loads.
To improve the friction wear performance of the aluminum alloy scroll disc of the scroll compressor under dry friction conditions, the C-MoS 2 -PTFE-PEEK coating was prepared on the surface of the 4032 aluminum alloy substrate by thermal spraying. The friction and wear performance of C-MoS 2 -PTFE-PEEK coating under dry friction conditions was investigated via friction wear test, hardness test, coating adhesion scratch test, x-ray diffraction analysis test, morphological characteristics, element distribution test, And XPS photoelectron spectrometer. Moreover, the frictional wear performance of the C-MoS 2 -PTFE-PEEK coating was compared with that of the anodic oxide film of 4032 aluminum alloy and the Ni-plated coating of 4032 aluminum alloy. The results show that the hardness of C-MoS 2 -PTFE-PEEK coating is 102.8 HV 0.2 . The C-MoS 2 -PTFE-PEEK coating has good lubrication properties under dry friction conditions due to the synergistic effect of MoS 2 and PTFE, which can effectively resist deformation and reduce the coefficient of friction. The average friction coefficient under 5N, 10N, and 15N loads are 0.12, 0.15, and 0.23, respectively. The Graphite can effectively form a solid lubricating film, improve the adhesion resistance of the composite, and cause the shallow and small wear mark of C-MoS 2 -PTFE-PEEK coating; The wear rate and friction coefficient of C-MoS 2 -PTFE-PEEK coating under different loads are lower than that of the anodic oxidation film of 4032 aluminum alloy and the Ni-plated coating of 4032 aluminum alloy, showing excellent anti-friction and wear resistance. The wear mechanism of C-MoS 2 -PTFE-PEEK coating under different loads is mainly fatigue wear, adhesive wear, and abrasive wear.