Rock sheds have been widely used to protect against rockfall. Traditionally, a cushion layer is placed on the top of a rock shed to reduce the impact force and dissipate energy. However, heavy cushion layers lead to high dead loads and increased construction costs. This paper discusses the concept of an impact‐resilient flexible buffer structure. On the basis of that concept, it also proposes a buffer structure mainly composed of springs, ring nets, spring rods, and support ropes, which can be used to replace the traditional cushion layer on a shed for rockfall protection. Full‐scale impact tests were conducted to study the impact‐resilient characteristic of the structure combined with numerical simulation. The dynamic responses of the buffer structure, including force, deformation, and energy dissipation, were analysed in depth. Finally, parametric numerical simulations of 33 models were conducted; the spring stiffness of these models ranged from 300 kN/m to 1500 kN/m; the impact energy ranged from 100 kJ to 2000 kJ. Moreover, simple approaches for estimating the impact force and braking distance of the buffer structure were proposed and verified using measured data obtained from the impact test.
To investigate the nonlinear mechanical behavior of the wire‐ring net, this paper presents a new numerical model that can collectively consider equivalence between numerical and actual wire rings. Quasi‐static tests, including tensile tests on steel wires and one‐ring specimens, and puncturing tests on net specimens were conducted. Based on the test results, the axial constitutive curves of steel wires were obtained. The linear correlation equations for the breaking loads of the one‐ring specimens and the puncturing strength of wire‐ring nets were established, both of which were related to the number of windings. The wire rings were modeled via an equivalent structure with a single winding and a circular cross section. Equivalence between the numerical and actual wire rings in terms of bending and tensile strength, total mass, contact with sliding friction, and rupture behavior were also derived and presented. In particular, the emphasis was on simulating the flattening effect, a phenomenon rarely accounted for in conventional numerical models. All dominant factors were reflected in a model with the material law by the input of material parameters. The proposed mechanical model was calibrated and verified by the data from the tests of the wire‐ring net. The calibrated mechanical model is also shown to successfully simulate a full‐scale test of a flexible rockfall protection barrier according to the ETAG027 standard.
Landslides frequently occur in forest areas with a steep hillside, especially when severely disturbed by human activities. After sustained heavy rainfall, a landslide occurred near the Tianwan tunnel entrance of the Chongqing-Huaihua railway in China. Fortunately, the landslide debris was successfully intercepted by a flexible barrier originally installed to stop rockfalls, which is, to date, the first publicly reported case of landslide debris having been successfully intercepted by a flexible barrier without any damage, in mainland of China. A field investigation was first conducted, and then a back analysis of the landslide mobility and the interaction between the landslide and the flexible barrier was carried out. The back analysis showed that the impact energy was three-times larger than the rated energy capacity of the flexible barrier. It also showed that the elongation of the brake rings and the deflection of the flexible barrier from the numerical simulation was comparable to that from the field measurements. The fact that these brake rings were not elongated to their limit indicated that the capacity of the flexible barrier still had a surplus. Finally, to investigate the maximum energy capacity of a flexible rockfall barrier in resisting landslide debris, parametric analyses of a flexible barrier impacted by landslide debris with different impact energies and velocities were carried out using a coupled ALE-FEM modeling technique. The results showed that the flexible barrier dissipated less than 40% of the total energy of the landslide debris. With an increase of impact energy, the energy dissipation ratio of the flexible barrier decreased linearly. The maximum energy capacity of a flexible rockfall barrier in resisting landslide debris is four-times that of resisting a rockfall.