Urban areas are mostly heterogeneous due to settlements and vegetation including forests, water bodies and many other land use and land cover (LULC) classes. Due to the overwhelming population pressure, urbanization, industrial works and transportation systems, urban areas have been suffering from a deficiency of green spaces, which leads to an increase in the variation of temperature in urban areas. This study investigates the conceptual framework design towards urban green space (UGS) and thermal variability over Kolkata and Howrah city using advanced remote sensing (RS) and geospatial methods. The low green space is located in the highly built-up area, which is influenced by thermal variations. Therefore, the heat stress index showed a high area located within the central, north, northwestern and some parts of the southern areas. The vegetated areas decreased by 8.62% during the ten years studied and the other land uses increased by 11.23%. The relationship between land surface temperature (LST) and the normalized difference vegetation index (NDVI) showed significant changes with R² values between 0.48 (2010) and 0.23 (2020), respectively. The correlation among the LST and the normalized difference built-up index (NDBI) showed a notable level of change with R² values between 0.38 (2010) and 0.61 (2020), respectively. The results are expected to contribute significantly towards urban development and planning, policymaking and support for key stakeholders responsible for the sustainable urban planning procedures and processes.

For companies, notably in the realms of energy and power supply, the essential requirement for highly efficient thermal transport solutions has become a serious concern. Current research highlighted the use of metallic oxides and carbon-based nanofluids as heat transfer fluids. This work examined two carbon forms (PEG@GNPs & PEG@TGr) and two types of metallic oxides (Al₂O₃ & SiO₂) in a square heated pipe in the mass fraction of 0.1 wt.%. Laboratory conditions were as follows: 6401 ≤ Re ≤ 11,907 and wall heat flux = 11,205 W/m². The effective thermal–physical and heat transfer properties were assessed for fully developed turbulent fluid flow at 20–60 °C. The thermal and hydraulic performances of nanofluids were rated in terms of pumping power, performance index (PI), and performance evaluation criteria (PEC). The heat transfer coefficients of the nanofluids improved the most: PEG@GNPs = 44.4%, PEG@TGr = 41.2%, Al₂O₃ = 22.5%, and SiO₂ = 24%. Meanwhile, the highest augmentation in the Nu of the nanofluids was as follows: PEG@GNPs = 35%, PEG@TGr = 30.1%, Al₂O₃ = 20.6%, and SiO₂ = 21.9%. The pressure loss and friction factor increased the highest, by 20.8–23.7% and 3.57–3.85%, respectively. In the end, the general performance of nanofluids has shown that they would be a good alternative to the traditional working fluids in heat transfer requests.