This study proposes a new phase-shift full-bridge (PSFB) converter with an integrated winding planar two-transformer for a low-voltage dc–dc converter (LDC). An LDC is a dc–dc converter that supplies power to a 12-V auxiliary battery (A_BAT) and loads from the main battery (M_BAT) of electric vehicles (EVs), used in low-voltage and high-current output applications. PSFB converter is widely used as a suitable topology for such systems. In order to improve the power density, the integrated planar magnetics is designed in the proposed PSFB converter. Furthermore, the size of the transformer is optimized considering the footprint and core loss of components. To confirm the validity of the proposed converter, a 2.1-kW prototype LDC with an input voltage range of 400–800 V and an output voltage of 14 V is analyzed, and the operating characteristics are described. The proposed converter achieves a maximum efficiency of 95.4% and a power density of 5.2 kW/L.
This paper proposes an active-clamp forward-flyback (ACFF) converter with an integrated planar transformer for wide-input voltage and high-output current applications, such as low-voltage direct-current (LDC) converters in electric vehicles. An integrated planar transformer that consists of a forward-flyback transformer, single primary winding, and efficient structure of secondary windings is adopted for the proposed converter, and since this transformer is implemented with a common four-layer printed circuit board (PCB) winding, a high power density and low cost of the proposed converter can be achieved. In addition, due to the low leakage inductance induced by the planar transformer, a reduced commutation period can be achieved, and it is possible to increase the switching frequency resulting in low volume of transformer. Although the integrated planar transformer has relatively high conduction loss, the active-clamp topology can significantly reduce the conduction loss on switches compared with widely used full-bridge (FB) converters because it only utilizes two switches and shows the low circulating current. As a result, the proposed converter with an integrated planar transformer has strengths in high power density and cost competitiveness without degraded efficiency, and it is a very attractive topology for LDC converters and other applications that require wide-input voltage and high-output current.
12 November 2025 in IEEE Transactions on Industrial Electronics
This article proposes a new integrated battery charging system (IBCS) for electric vehicles, combining a dual-active bridge (DAB) converter for the on-board charger (OBC) and a phase-shift full-bridge (PSFB) converter for the low-voltage dc–dc converter (LDC). Unlike conventional IBCSs, which employ the output inductors and transformer separately, the proposed IBCS integrates them using a two-transformer structure, thereby reducing the overall volume and the number of conducting components on the LDC secondary side. In addition, synchronous rectifiers (SRs) with an optimal driving scheme are introduced to minimize conduction losses. Furthermore, the transformers are designed to optimize the efficiency of the proposed IBCS in both grid-to-vehicle (G2V) and vehicle-to-grid (V2G) modes. These optimizations are based on a detailed analysis, including the coupling effects between the OBC and LDC and the impact of leakage inductances on the OBC primary and secondary sides, which have not been thoroughly addressed in previous studies. As a result, the proposed IBCS can achieve high power density and efficiency. Finally, to validate its performance, a prototype integrating an 11 kW OBC with a 2 kW LDC is built and tested, demonstrating a peak efficiency of 97.1% in both the G2V and V2G modes.