Gallium nitride (GaN)-based high-electron mobility transistors (HEMTs) are widely used in high power and high frequency application fields, due to the outstanding physical and chemical properties of the GaN material. However, GaN HEMTs suffer from degradations and even failures during practical applications, making physical analyses of post-failure devices extremely significant for reliability improvements and further device optimizations. In this paper, common physical characterization techniques for post failure analyses are introduced, several failure mechanisms and corresponding failure phenomena are reviewed and summarized, and finally device optimization methods are discussed.
In the current study, the effects of cracks in source field plates (SFPs) on the electrical performance of AlGaN/GaN high electron mobility transistors (HEMTs) are investigated systematically using numerical simulation. In detail, the influence of crack width and junction angle in SFPs on device performance is studied. The results indicate that the SFP structure increases the breakdown voltage of a device, but the occurrence of cracks causes premature breakdown, which is confirmed experimentally by the structural analysis of these devices after breakdown. With an increase in crack width, the electrical performance becomes worse. A beveled SFP architecture is proposed by increasing the angle at the SFP junction to reduce the probability of cracking and enhance the reliability of the device. However, with an increase in bevel angle, the modulation effect of the SFP on the channel electric field is gradually weakened. Therefore, it is necessary to balance the relationship between electrical performance and bevel angle according to the actual demands. This work provides potential support for SFP structural optimization design for AlGaN/GaN HEMTs.
Reconfigurable radio frequency (RF) attenuators are critical passive components for 5G-Advanced and emerging 6G wireless systems. Conventional tunable attenuators rely on solid-state switches combined with fixed resistor networks, which suffer from unavoidable static power consumption and severe parasitic degradation at high frequencies. Here, we systematically demonstrate HfO2-based non-volatile memristors as RF switches with tunable ON-state resistance (RON), enabling a switching-attenuation-integrated multistate attenuator. The fabricated Au/HfO2/Ag devices exhibit stable bipolar resistive switching with an ON/OFF ratio exceeding 109, reliable retention of 105 s, and programmable RON continuously tuned from 5.8 Ω to 197.5 Ω. On-wafer RF characterizations from 10 MHz to 43.5 GHz reveal low insertion loss (−0.53 dB), high isolation (−26.8 dB), and clear scaling laws governing the effects of device geometry and RON on RF performance. Leveraging these unique characteristics, we propose a symmetric π-type programmable all-memristor attenuator architecture with a cascaded 2-unit configuration. The design achieves 12 discrete attenuation levels from 2 dB to 24 dB, a return loss better than 10 dB across the full band, and zero static power consumption without additional passive components or bias networks. This work establishes the fundamental material-device-RF performance relationship in HfO2-based RF switches and provides a compact, low-power, and highly integrable solution for next-generation reconfigurable RF front-ends.