The aim of this work was to examine the applicability of nitrogen-doped bamboo-shaped carbon nanotubes (BCNTs) as conductive additive in bearing grease. To synthesize BCNTs, catalytic chemical vapour deposition (CCVD) method was used by applying butylamine as nitrogen containing carbon source. During the preparation of the polydimethylsiloxane (PDMS)-based lubricants BCNT (1.5 wt% or 3 wt%) and Li-soap (5 wt% or 10 wt%, lithium-stearate) or colloidal silicon dioxide (1 wt% and 1.5 wt% Aerosil 200) was added and mixed by using a highly efficient ultrasonic technique. By adding lithium-soap to the BCNT loaded greases their lubricity improved. The electrical conductivity of greases was measured in stationary state and in rotating bearing (during operation) by using an in-house developed instrument. The nanotube containing samples have shown good electrical conductivity (7–18.5 mS). The friction torque was also calculated based on the measurements of our in-house developed instrument. Efficient friction has been achieved with the 1.5 wt% BCNT loaded samples (6.1 and 5.1 Nmm). Thus, small amount of BCNT is enough to develop a conductive grease formula. All in all, the 3% BCNT and 1.0% colloidal SiO2 containing PDMS base-oil with 50 mm/s viscosity is well suitable for loading of ball bearings.
In this work, three different polyurethane (PU) foams were prepared by mixing commonly used isocyanate and polyol with different isocyanate indices (1.0:0.8, 1.0:1.0, 1.0:1.1). Then, the prepared polyurethane foam samples were coated by dip-coating with a fixed ratio of nitrogen-doped, bamboo-shaped carbon nanotubes (N-BCNTs) to obtain pressure sensor systems. The effect of the isocyanate index on the initial resistance, pressure sensitivity, gauge factor (GF), and repeatability of the N-BCNT/PU pressure sensor systems was studied. The pore volume was crucial in finetuning the PU-foam-based sensors ability to detect large strain. Furthermore, large pore volume provides suitable spatial pores for elastic deformation. Sensors with large pore volume can detect pressure of less than 3 kPa, which could be related to their sensitivity in the high range. Moreover, by increasing the pore volume, the electrical percolation threshold can be achieved with a minimal addition of nanofillers. On the other hand, PU with a smaller pore volume is more suitable to detect pressure above 3 kPa. The developed sensors have been successfully applied in many applications, such as motion monitoring and vibration detection.
In this study, a novel technology is reported to prepare a piezoresistive polyurethane-silicone rubber nanocomposite. Polyurethane (PU) foam was loaded with a nitrogen-doped bamboo-shaped carbon nanotube (N-BCNT) by using dip-coating, and then, impregnated with silicone rubber. PU was used as a supporting substrate for N-BCNT, while silicone rubber was applied to fill the pores of the foam to improve recoverability, compressive strength, and durability. The composite displays good electrical conductivity, short response time, and excellent repeatability. The resistance was reduced when the amount of N-BCNT (0.43 wt %) was increased due to the expanded conductive path for electron transport. The piezoresistive composite has been successfully tested in many applications, such as human monitoring and finger touch detection.