Chenzhen Ji

Dr. Chenzhen Ji

School of Mechanical Engineering, Tongji University, 4800 Cao'an Road, Shanghai 201804, China
orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 May 2022 in Aerospace Science and Technology
Verified
Journal Article
Closed access
XSXiuyang Song
Xiuyang Song
TZTong Zhu
Tong Zhu
DPDeng Pan
Deng Pan
ZWZiyu Wang
Ziyu Wang
Chenzhen JiChenzhen Ji
Chenzhen Ji
DZDan Zhao
Dan Zhao

19 May 2023 in Applied Sciences
Verified
Journal Article
Open access
PDF file
DPDeng Pan
Deng Pan
Chenzhen JiChenzhen Ji
Chenzhen Ji
TZTong Zhu
Tong Zhu
The response of flames’ heat release to acoustic excitation is a critical factor for understanding combustion instability. In the present work, the nonlinear heat release response of a methane–air non-premixed flame to low-frequency acoustic excitations is experimentally investigated. The flame describing function (FDF) was measured based on the overall CH* chemiluminescence intensity and the velocity fluctuations obtained by the two-microphone method. The CH* chemiluminescence and schlieren images were analyzed for revealing the mechanism of nonlinear response. The excitation frequency ranges from 10 Hz to 120 Hz. The forced relative velocity fluctuation amplitude ranges from 0.10 to 0.50. The corresponding flame Strouhal number (Stf) ranges from 0.43 to 4.67. The study has shown that the flame length responds more sensitively to changes in excitation amplitude when subjected to relatively high-frequency excitations. The normalized flame length (Lf/D) decreases from 3.79 to 2.37 with the increase in excitation amplitude at an excitation frequency of 100 Hz. The number of oscillation zones along the flame increases with increasing excitation frequency, which is consistent with the increase in the Stf. The low-pass filtering characteristic of FDF is caused by the dispersion of multiple oscillation zones, as well as the cancellation effect of the adjacent oscillation zones under relatively high-frequency excitation. The main mechanism for the local gain peak and valley is the cancellation effect of positive and negative oscillation zones with various Stf. When two adjacent oscillation regions have similar amplitudes, the overall phase-lag becomes more sensitive to changes in excitation frequency and amplitude. This sensitivity leads to nonlinear anomalous changes in the phase-lag near the frequency corresponding to the gain valley. The calculated disturbance convection time is consistent with the measured time delay in the short flame scenario. Further research is required to determine whether the identified agreement is a result of the consistent occurrence of the oscillation zone in close proximity to the flame’s center of mass, in conjunction with a precise determination of the average convective velocity.

5 June 2024 in Aerospace Science and Technology
Verified
Journal Article
Closed access
EKEnlei Ke
Enlei Ke
Chenzhen JiChenzhen Ji
Chenzhen Ji
MWMengming Wang
Mengming Wang
DPDeng Pan
Deng Pan
TZTong Zhu
Tong Zhu

27 September 2022 in Applied Sciences
Verified
Journal Article
Open access
PDF file
PZPeng Zhu
Peng Zhu
QWQian Wang
Qian Wang
DPDeng Pan
Deng Pan
TZTong Zhu
Tong Zhu
Chenzhen JiChenzhen Ji
Chenzhen Ji
The ignition process of fuel plays an important role in the flame development and emission characteristics, which has attracted intensive attention in the combustion field. However, the transient ignition process for jet flames under acoustic excitation is rarely reported. In the current study, the effect of external acoustic excitation with different frequencies on the ignition process of methane jet diffusion flames has been studied experimentally using high-speed color and schlieren imaging systems. The fuel nozzle used in the experiment features a concentric ring structure, with fuel in the middle and air around it. The acoustic excitation was added to the air side through the loudspeaker, and the frequency of the acoustic excitation was set as 10 Hz, 30 Hz, 50 Hz and 100 Hz, respectively, while a case without external excitation was used as the control group. It is found that the periodic vortex structure propagates downstream in the flow field after acoustic excitation is added, which leads to an uneven velocity distribution in the flow field and the appearance of a local high-speed zone. The acoustic excitation of 30 Hz and 50 Hz can reduce the probability of successful ignition, which is mainly because the acoustic wave propagates in the flow field and causes drastic velocity changes near the ignition position. For the case of 100 Hz, the acoustic perturbation is confined in a small region near the nozzle exit, while the flow field velocity is slightly higher than the case without acoustic excitation.

25 April 2024 in Aerospace
Verified
Journal Article
Open access
PDF file
Chenzhen JiChenzhen Ji
Chenzhen Ji
WSWentao Shi
Wentao Shi
EKEnlei Ke
Enlei Ke
JCJiaying Cheng
Jiaying Cheng
TZTong Zhu
Tong Zhu
Xinyan LiXinyan Li
Xinyan Li
To meet the requirements of achieving higher efficiency and lower NOx pollution, the flame temperature in gas turbine combustors increases continually; thus, the effusion-cooling technology has been used to ensure the combustor liner remains within the allowed temperature, by which the combustion characteristics and emission behavior are possibly influenced. In order to investigate the effects of dome cooling air flow on combustion characteristics and NOx emissions, three-dimensional combustion simulations for a swirl-stabilized can-type gas turbine combustor are carried out in this work by using the computational fluid dynamics (CFD) method. Through adjusting the ratio of the dome cooling air flow and the dilution cooling air flow, the characteristics of flow field, temperature distribution and NOx emissions under each work condition are analyzed. At different ratios of the dome-cooling air flow to the total air flow, the flow velocity field in the region near the center of the combustion chamber is not changed much, while the velocity field near the chamber wall shows a more significant difference. The temperature in the outer recirculation zone within the combustion chamber is effectively reduced as the dome cooling air flow increases. By analyzing the distribution characteristics of the concentration of OH*, it is demonstrated that the dome cooling air flow does not have a direct effect on the reaction of combustion. It is also found that as the ratio of the dome cooling air flow to the total air flow increases from 0 to 0.15, the value of the NOx emissions drops from 28.4 to 26.3 ppmv, about a 7.4% decrease. The distribution of the NOx generation rate in the combustion chamber does not vary significantly with the increasing dome cooling air flow. Furthermore, by calculating the residence time in different stages, when the the ratio of the dome cooling air flow to the total air flow varies from 0 to 0.15, the residence time in the pilot stage decreases obviously, from 42 ms to 18 ms. This means that reduction in residence time is the main factor in the decrease of NOx emissions when the dome cooling air flow increases.

1 September 2025 in Physics of Fluids
Verified
Journal Article
Closed access
CZCaichao Zheng
Caichao Zheng
Chenzhen JiChenzhen Ji
Chenzhen Ji
MWMengming Wang
Mengming Wang
Sheikh Muhammad FarhanSheikh Muhammad Farhan
Sheikh Muhammad Farhan
SLShikang Lu
Shikang Lu
Dan ZhaoDan Zhao
Dan Zhao
Efficient hydrogen-enriched fuel–air mixing in a micromix combustor is a key factor that influences the combustion process, flow dynamics, and NOx formation. This study focuses on a single nozzle within a hydrogen-enriched micromix combustor to identify optimal fuel–air mixing strategies and explore the mixing mechanism. Through detailed numerical investigations of gas flow and geometric parameters by Reynolds-averaged Navier–Stoke and large eddy simulation, the influence on the cold-flow field and mixing performance is analyzed. The results indicate that the momentum ratio significantly affects the initial jet trajectory and vorticity magnitude; an optimal momentum ratio of approximately 30 yielded the best mixing characteristics. Preheating the air to 575 K was observed to increase turbulent viscosity and molecular kinetic energy, thereby promoting more effective momentum and mass diffusion rates. Increasing the number of fuel tubes and reducing the tube diameter expanded the diffusion region, improving hydrogen-enriched fuel–air interaction. In addition, higher mass flow rates resulted in deeper jet penetration, while the jet angle significantly influenced the spatial fuel distribution and vortex structure within the premixing tube. A properly adjusted jet angle of 30° led to the breakdown of large vortices into smaller structures, thereby maximizing the contact surface between hydrogen-enriched fuel and air and, thus, enhancing the mixing characteristics. Overall, the micromix combustor demonstrates strong potential for achieving efficient, small-scale fuel–air mixing, which is essential for clean, low-emission combustion.