Using nano-sized energetic materials as fuel additives to hydrocarbon gel fuel has gained in popularity due to the advantages of higher energy density and shorter ignition delay times. Combustion characteristics and application performance of gel fuel containing 16% wt aluminum nanoparticles were investigated on a direct-connect scramjet platform with an inflow Mach number of 2, an inflow total temperature of 1700 K, and a fuel equivalence ratio ranging from 0.6 to 1.0. The gel fuel could be stably injected and atomized efficiently by a nitrogen-assisted injector. The combustion efficiency of JP-[ ]Al gel fuel was 4.27% higher than that of JP-10 gel fuel, while the addition of aluminum increased the density specific impulse by 6.34%, indicating that the addition of aluminum nanoparticles indeed presented a positive effect on combustion and engine performance. The wall deposition phenomenon of gel fuel was particularly slight as compared to that of slurry fuel cases. Unlike nanoaluminum-blended slurry fuel, nanoaluminum-blended gel fuel controlled the potential risk of increasing thermal load to the least degree within the scope of existing research, with wall heat flux increasing by 7.43% solely as a result of elevated airflow temperature, indicating its advantageous application prospect.
The mixing process and distribution characteristics of a supercritical endothermic hydrocarbon fuel (EHF) jet injected into a supersonic crossflow were investigated by experimental and numerical methods, respectively. The schlieren system and acetone planar laser-induced fluorescence (PLIF) optical system were used to capture the flow-field structural characteristics and instantaneous plume. The mixture and real gas models were employed to calculate the interaction of a transverse jet and supersonic crossflow and reveal a good accuracy with the experimental results. The mixing efficiency and total pressure loss were analyzed based on the numerical results. The results indicate that the supercritical-state EHF directly changes to a gaseous state as it enters the supersonic crossflow from the injector. The EHF jet plume boundary increases with the increasing momentum flux ratio (q). As the streamwise and spanwise distance increases, the traverse heights and expand width increase, and the EHF jet plume presents a semicircle shape in the cross-sectional plane. With the increase in the traverse direction, the concentration distribution shows a fast and then slow power exponential decreasing law; the highest concentration point starts from the near-wall region and rises in the transverse direction with the flow distance increasing. For the same injection condition, the higher the inflow Mach number, the higher the mixing efficiency. For the same Ma, the mixing efficiency is better for the case with low injection pressure and high injection temperature. The total pressure loss is greater in the higher Ma, and high injection pressure conditions cause greater total pressure loss.
Shock waves are of great interest in many fields of science and engineering, but the mechanisms of their formation, maintenance and dissipation are still not well understood. While all transport processes existing in a shock wave contribute to its compression and irreversibility, they are not of equal importance. To figure out the roles of viscosity and heat conduction in shock transition, the existence of smooth shock solutions and the counter-intuitive entropy overshoot phenomenon (the specific entropy is not monotonically increasing and exhibits a peak inside the shock front) are theoretically and numerically investigated, with emphasis on the effects of viscosity and heat conduction. Instead of higher-order hydrodynamics, the Navier–Stokes formalism is employed for its stability and simplicity. Supplemented with nonlinear thermodynamically consistent constitutive relations, the Navier–Stokes equations are adequate to demonstrate the general nature of shock profiles. It is found that heat conduction cannot sustain strong shocks without the presence of viscosity, while viscosity can maintain smooth shock transition at all strengths, regardless of heat conduction. Hence, the critical role in shock compression is played by viscosity rather than heat conduction. Nevertheless, the dispensability of heat conduction would not compromise its essential role in the emergence of an entropy peak. It is the entropy flux resulting from heat conduction that neutralises the positive entropy production and thus prevents the decreasing entropy from violating the second law of thermodynamics. This mechanism of entropy overshoot has not been addressed previously in the literature and is revealed using the entropy balance equation.