In this paper, flame stabilization and propagation inside a kerosene-fueled two-stage strut dual-mode scramjet combustor is experimentally investigated at Mach 2 and Mach 3 with the stagnation temperature of 958, 1,163, and 1,626°C (1,231, 1,436, and 1,899 K). A high-speed imaging camera was used to record the flame structure during the combustion. The results show that when the scramjet is operating at lower stagnation temperatures of 958 and 1,163°C (1,231 and 1,436 K), the flame flashback equivalence ratio is much higher than the flame blowout limit, and the upstream strut can get a stabilized flame once it is reignited. A higher stagnation temperature and a lower inflow Mach number are advantageous to trigger flame flashback. When the scramjet is operating at a higher stagnation temperature of 1,626°C (1,899 K), continuous and oscillatory change of the flame and the axial wall pressure profiles were obtained.
To better understand the characteristics of coupled heat transfer in liquid rocket engines, a calculation scheme is proposed in this paper. This scheme can simulate the coupled heat transfer processes, including combustion and flow in the thrust chamber, radiation heat transfer, heat conduction in the wall, heat transfer of coolant flow in the cooling channel, and gas film cooling in the thrust chamber wall. The numerical method used in each physical area, the data transfer method between each computing module, the strategy of data transfer on the coupling interface, the calculation process, and the convergence criterion are all introduced in detail. The calculation scheme was verified by analyzing a water-cooled nozzle. Then, the coupled heat transfer calculation was carried out for a liquid rocket engine using a propellant composed of unsymmetrical dimethylhydrazine and dinitrogen tetroxide. Two working conditions were analyzed: whether the gas film cooling was performed or not. The results showed that the algorithm successfully indicated the protective effect of the gas film on the wall surface, and the calculation results were reasonable. It played a guiding role for the coupled heat transfer of the liquid rocket engine using a composite cooling method.
The mixing process and distribution characteristics of a supercritical endothermic hydrocarbon fuel (EHF) jet injected into a supersonic crossflow were investigated by experimental and numerical methods, respectively. The schlieren system and acetone planar laser-induced fluorescence (PLIF) optical system were used to capture the flow-field structural characteristics and instantaneous plume. The mixture and real gas models were employed to calculate the interaction of a transverse jet and supersonic crossflow and reveal a good accuracy with the experimental results. The mixing efficiency and total pressure loss were analyzed based on the numerical results. The results indicate that the supercritical-state EHF directly changes to a gaseous state as it enters the supersonic crossflow from the injector. The EHF jet plume boundary increases with the increasing momentum flux ratio (q). As the streamwise and spanwise distance increases, the traverse heights and expand width increase, and the EHF jet plume presents a semicircle shape in the cross-sectional plane. With the increase in the traverse direction, the concentration distribution shows a fast and then slow power exponential decreasing law; the highest concentration point starts from the near-wall region and rises in the transverse direction with the flow distance increasing. For the same injection condition, the higher the inflow Mach number, the higher the mixing efficiency. For the same Ma, the mixing efficiency is better for the case with low injection pressure and high injection temperature. The total pressure loss is greater in the higher Ma, and high injection pressure conditions cause greater total pressure loss.
Shock waves are of great interest in many fields of science and engineering, but the mechanisms of their formation, maintenance and dissipation are still not well understood. While all transport processes existing in a shock wave contribute to its compression and irreversibility, they are not of equal importance. To figure out the roles of viscosity and heat conduction in shock transition, the existence of smooth shock solutions and the counter-intuitive entropy overshoot phenomenon (the specific entropy is not monotonically increasing and exhibits a peak inside the shock front) are theoretically and numerically investigated, with emphasis on the effects of viscosity and heat conduction. Instead of higher-order hydrodynamics, the Navier–Stokes formalism is employed for its stability and simplicity. Supplemented with nonlinear thermodynamically consistent constitutive relations, the Navier–Stokes equations are adequate to demonstrate the general nature of shock profiles. It is found that heat conduction cannot sustain strong shocks without the presence of viscosity, while viscosity can maintain smooth shock transition at all strengths, regardless of heat conduction. Hence, the critical role in shock compression is played by viscosity rather than heat conduction. Nevertheless, the dispensability of heat conduction would not compromise its essential role in the emergence of an entropy peak. It is the entropy flux resulting from heat conduction that neutralises the positive entropy production and thus prevents the decreasing entropy from violating the second law of thermodynamics. This mechanism of entropy overshoot has not been addressed previously in the literature and is revealed using the entropy balance equation.
The binary scaling law is a classical similarity law used in analysing hypersonic flow fields. The objective of this study is to investigate the applicability of the binary scaling law in thermochemical non-equilibrium airflow. Dimensional analysis of vibrational and electron–electronic energy conservation equations was employed to explore the theoretical reasons for the failure of the binary scaling law. Numerical simulation based on a multi-temperature model (translational–rotational temperature T, electron–electronic excitation temperature ${T_e}$ and the vibrational temperatures of ${\textrm{O}_2}$ and ${\textrm{N}_2}$ , $\; {T_{{v_{{\textrm{O}_2}}}}}$ and ${T_{{v_{{\textrm{N}_2}}}}}$ ) with two chemical models (the Gupta model and the Park model) was adopted to study the accuracy of the binary scaling law for electron distribution at high altitude with extremely high Mach number. The results of theoretical analysis indicate that the three-body collision reactions and the translation–electron energy exchange from collisions between electrons and ions, ${Q_{t - e\_ions}}$ , can cause the failure of the binary scaling law. The results of numerical simulation show that the electron-impact ionization reactions are the main reasons for the invalidation of the binary scaling law for electron distribution at high altitude with high Mach number. With an increase of free-stream Mach number, the negative effect on the binary scaling law caused by ${Q_{t - e\_ions}}$ cannot be ignored.
The numerical simulation of a scramjet is often based on the thermal equilibrium model, but the flow inside the inlet and isolator is likely to be in thermal nonequilibrium due to shock-based compression. The objective of this study is to investigate the effect of thermal nonequilibrium on the mass flow rate captured by the scramjet inlet. Numerical simulations based on the thermochemical nonequilibrium model (thermal nonequilibrium) and the chemical nonequilibrium model (thermal equilibrium) were adopted to study the mass flow rate of the HyShot II scramjet with the incoming flow Mach numbers [ ] ranging from 6.0 to 8.0. The results show that the maximum difference of the mass flow rate between thermal nonequilibrium and equilibrium reaches 10.7% at [ ] with [ ]. The primary cause of the mass flow rate difference is the oblique shock wave angle difference between nonequilibrium and equilibrium. The relative magnitudes of oblique shock wave angles and flow parameter ratios across the wave under equilibrium and nonequilibrium are theoretically discussed in an intuitive way. A simplified model for the HyShot II is established to predict the mass flow rate difference between thermal nonequilibrium and equilibrium. The result shows that the expression of captured mass flow rate has a significant amplification effect on the slight difference of wave angles between thermal nonequilibrium and equilibrium, which means that the effect of thermal nonequilibrium cannot be ignored for scramjet in some cases.