In this study, the spring constant of an accelerometer with a liquid-type proof mass was analyzed. Unlike a general solid-type microelectromechanical system accelerometer, the Laplace pressure is considered a restoring force in the analyzed accelerometer. Using a base excitation mathematical model, the sensor output could be estimated for a specific spring constant. Although the estimated sensor output data fit well with the experimental results, the spring constant of the device could also be determined dynamically (for oscillations below 5 Hz). Moreover, the damping constants could be inferred depending on whether sandblasting treatment was performed. Finally, the effects of the oscillation, surface condition, and volume of liquid metal droplets on the spring constant were analyzed.
25 August 2023 in Journal of Micromechanics and Microengineering
The impact dynamics of a droplet falling onto a substrate is significant in various applications such as inkjet printing, spray coating, and bioprinting. Generally, several factors, such as the fluid properties (e.g. viscosity or surface tension) and substrate characteristics (e.g. surface roughness or flexibility) govern whether falling droplets spread or splash. In this study, we experimentally investigate droplet impact dynamics on a thin, flexible membrane for various Weber numbers (230 < We < 600) and membrane stiffnesses, which can be controlled by the applied tensile force. In addition, the effect of membrane vibration on impact behavior is considered. In the high Weber number regime, splashing is dominant, regardless of the membrane stiffness. In contrast, in the low Weber number regime, a transition between splashing and deposition is observed, depending on the membrane stiffness. In short, flexible membrane vibration induces droplet splashing despite the insufficient kinetic energy of the droplet. Increasing the stiffness of the membrane contributes to the suppression of droplet splashing by minimizing membrane vibration.
Conventional 3D printing methods require the addition of a supporting layer in order to accurately and reliably fabricate the desired final product. However, the use of supporting material is not economically viable, and during the process of removing the supporting material, the shape or the properties of the final product may be distorted. In our previous work, we proposed and demonstrated the concept of a new 3D printing method that utilizes the in situ light as a guide for the fabrication of freestanding overhanging structures without the need for supporting material. In this study, the influence of the light intensity on the diameter of the structure and the thickness of the layer produced per droplet is analyzed in order to identify the geometric range of structures that can be fabricated by the new 3D printing method. As the intensity of the light increased, the diameter of the structure also increased and the thickness of the layer per droplet decreased. This result is determined by a combination of factors; (1) the rebound motion of the photocurable droplet and (2) the surface area of the structure that needs to be covered.
In this study, a pneumatic dispenser driven by a flexible membrane with a capacitive-type sensor using an SLA-type 3D printer was fabricated. It was confirmed that a single droplet in the range of approximately 400–450 nL could be ejected from the current processed 200-μm-diameter nozzle. The deformation varied according to the magnitude and time of the positive pressure applied to the membrane sensor. In addition, the signals of the normal dispensing and abnormal states, in which the solution was not ejected when the inlet pressure was removed, were measured and compared. The base capacitance-to-digital converter (CDC) value decreased when the inlet pressure was removed. Thus, it was able to confirm the feasibility of monitoring the normal and abnormal ejection status of the pneumatic dispenser.