Metallic implants have been considered as promising alternatives to traditional implants due to their biocompatibility and favorable biodegradability properties. However, one of the major challenges in using these implants is the relatively fast degradation rate of metal alloys in the body's electrolyte environment, which can lead to early loss of performance and the release of undesirable degradation products. Applying appropriate coatings with suitable performance on the surface of metal implants can be an effective solution to control the rate of deterioration and increase their stability in the body environment. In this comprehensive study, various methods of coating metal implants with calcium phosphate or hydroxyapatite structures, including sol-gel, chemical deposition (such as hydrothermal deposition), and thermal spraying (such as plasma spray) methods have been fully investigated. The benefits and drawbacks of each of these techniques in relation to the properties of the resulting coating such as surface morphology, chemical composition, adhesion to the substrate, porosity and crystal structure, anti-corrosion performance, their impact on the biological performance of the implant in terms of biocompatibility, degradation rate control, and mechanical properties, as well as limitations related to the coating process are described. The results of this comprehensive study provide valuable and key guidance for choosing the most suitable coating and coating method according to the type of medical application considered for metal implants.
4 August 2021 in Corrosion Engineering, Science and Technology: The International Journal of Corrosion Processes and Corrosion Control
The effect of different concentrations of nanoclay incorporated in the epoxy coating containing 8-hydroxyquinoline (8-HQ) on early corrosion detection, electrochemical and optical properties of the applied coating was investigated. The 8-HQ and nanoclay composite samples were characterised by UV–Vis spectroscopy, FE-SEM, EDS, XRD, EIS, fluorescence spectroscopy and microscopy. Then, the optimised coating containing 8-HQ and nanoclay was applied on the Ti–Ni conversion coated steel for further analysis. Adhesion measurements indicated that the adhesion strength of the 8-HQ + Nano + TiNiCC was 4.6 ± 0.45 MPa with dominant cohesion failure. Based on the EIS measurement, the polarisation resistance of Ti–Ni modified steel coated with 0.1 wt-% 8-HQ and 2 wt-% nanoclay composite was about 1.5 × 1010 ohm.cm2 even after 4 weeks immersion in 3.5 wt-% NaCl solution. During the same period as a result of fluorescence microscopic study, the fluorescent spot appeared as a result of Fe2+/Fe3+ ions production at anodic regions.