The effect of different concentrations of nanoclay incorporated in the epoxy coating containing 8-hydroxyquinoline (8-HQ) on early corrosion detection, electrochemical and optical properties of the applied coating was investigated. The 8-HQ and nanoclay composite samples were characterised by UV–Vis spectroscopy, FE-SEM, EDS, XRD, EIS, fluorescence spectroscopy and microscopy. Then, the optimised coating containing 8-HQ and nanoclay was applied on the Ti–Ni conversion coated steel for further analysis. Adhesion measurements indicated that the adhesion strength of the 8-HQ + Nano + TiNiCC was 4.6 ± 0.45 MPa with dominant cohesion failure. Based on the EIS measurement, the polarisation resistance of Ti–Ni modified steel coated with 0.1 wt-% 8-HQ and 2 wt-% nanoclay composite was about 1.5 × 1010 ohm.cm2 even after 4 weeks immersion in 3.5 wt-% NaCl solution. During the same period as a result of fluorescence microscopic study, the fluorescent spot appeared as a result of Fe2+/Fe3+ ions production at anodic regions.
21 June 2024 in Colloids and Surfaces A: Physicochemical and Engineering Aspects
This study examines the efficacy of icephobic polyurethane nanocomposite coatings in mitigating corrosion on an aluminum substrate. A titanium-based conversion coating is applied to modify the substrate, and the research focuses on optimizing the dual functionalities of icephobicity and anticorrosion within the polyurethane coatings while ensuring strong substrate adhesion. The coatings are formulated using fluoropolyol, isocyanate, and silica nanoparticles treated with polydimethylsiloxane. Surface properties are analyzed using contact angles, contact angle hysteresis measurements, and atomic force microscopy, and the coatings’ icephobicity is evaluated through differential scanning calorimetry, freezing time delay, ice adhesion under impact and non-impact conditions, and ice accretion tests. The corrosion resistance and adhesive strength of the coatings are assessed using electrochemical impedance spectroscopy and cross-cut tests, respectively. Increasing the concentration of silica nanoparticles to 10 wt.% increases contact angles to 167°, although the 4 wt.% coating produces the lowest contact angle hysteresis (3° ± 0.5°) and ice nucleation temperature (−23 °C). The latter coating is then applied to a substrate pretreated with a titanium/cerium-based conversion coating. This prepared surface maintains an ice adhesion of about 15 kPa after 15 icing/de-icing cycles and provides approximately 90 days of surface protection (|Z|lf = 1.6 × 109 Ω·cm2). Notably, the impedance value exceeds that of untreated substrates, underscoring the effectiveness of the titanium/cerium-based conversion coating in enhancing both corrosion resistance and coating adhesion to the substrate.
2 September 2025 in Materials Today Communications
Aluminum and its alloys are employed in different industries due to their versatile properties (low density, resistance to corrosion, thermal conductivity). However, the corrosion properties of these alloys can be enhanced through protection methods. In this paper, the effect of surface treatment through atmospheric pressure plasma on the corrosion properties of a 6061 aluminum alloy was evaluated. The corrosion resistance was evaluated using electrochemical impedance spectroscopy. The jet-substrate distance and number of passes were selected as the plasma process parameters. The plasma treatment allowed the formation of a passive layer that exhibits higher corrosion resistance than the untreated substrate, corresponding to an increase of nearly three orders of magnitude in polarization resistance. Further, the passive layer’s morphological characteristics and chemical composition were analyzed through scanning electron microscopy with energy dispersive spectroscopy, optical profilometry, and X-ray photoelectron spectroscopy, where an increase of around 40% in oxygen content supports the presence of an oxygen-rich layer on the surface.