This research aims to evaluate the application of babassu mesocarp starch in the development of polymeric films compared to corn starch widely exploited due to its abundance and worldwide availability. Thus, films based on blends of poly(lactic acid)/poly(butylene adipate-co-terephthalate) (PLA/PBAT) containing commercial corn starch or starch extracted from the babassu mesocarp were developed by means of flat extrusion. The films were characterized and the results indicate that the color, wettability and surfaces depend on the type of starch added. Films containing babassu mesocarp starch present rougher, opaque surfaces with greater water resistance than those with corn starch. The data from this research suggest that both babassu mesocarp and corn starch are alternatives for the production of polymeric films.

The aim of this work was to produce filaments of PLA/PBAT and NPK fertilizer adsorbed on organophilized bentonite intended for application in the prototyping of biodegradable agricultural artifacts in 3D printing, using the Fused Deposition Modeling (FDM) technique. This is the first time that we have reported this composite for a 3D printing approach. Systems containing PLA/PBAT, organobentonite and NPK were initially processed in an internal mixer and later extruded as filaments in a single-screw extruder. The prototypes were printed by FDM. Structural, morphological and thermal properties, as well as NPK releasing, were investigated. The results suggest that exfoliated and/or intercalated nanocomposites were obtained by the organoclay addition to the PLA/PBAT blend. The morphological analysis revealed a good surface quality of the impressions. Systems containing organobentonite released approximately 22% less fertilizer in 24 h compared to the systems without organobentonite. This difference is due to the higher concentration of nanoparticles that generate more barriers to the diffusion of NPK. The release data for these systems had a better fit to the kinetic model of Korsmeyer-Peppas. Thus, studied filaments have the potential to retard the release of fertilizer and are suitable for further development of structures for agricultural applications by FDM.

Polymer processing parameters may considerably affect final product characteristic as, if properly chosen, these parameters may lead to products with optimal properties. The aim of this work is to evaluate the rheological characteristics of poly(ethylene terephthalate) (PET) by torque rheometry, as well as to estimate its incipient degradation rate during processing in an internal laboratory mixer. In order to estimate the temperature coefficient of the viscosity (β), and the pseudoplasticity index (n) of PET, two sets of experiments need to be performed. In the first one, the polymer is processed at three different temperatures at a single rotor speed for 10 min, getting temperature coefficient of the viscosity equal to β = 0.053 °C-1. In the second set of experiments, the resin (PET) is processed at a single temperature at six different rotor speeds for the same time interval and the pseudoplasticity index was determined, n = 0.78. From the results obtained, it is possible to indicate the internal mixer as an equipment not only for mixing polymers or composites, but as a tool for determining important rheological variables for predicting degradative processes.