Unsafe food is estimated to cause 600 million cases of foodborne disease, annually. Thus, the development of methods that could assist in the prevention of foodborne diseases is of high interest. This review summarizes the recent progress toward rapid microbial assessment through (i) spectroscopic techniques, (ii) spectral imaging techniques, (iii) biosensors and (iv) sensors designed to mimic human senses. These methods often produce complex and high-dimensional data that cannot be analyzed with conventional statistical methods. Multivariate statistics and machine learning approaches seemed to be valuable for these methods so as to “translate” measurements to microbial estimations. However, a great proportion of the models reported in the literature misuse these approaches, which may lead to models with low predictive power under generic conditions. Overall, all the methods showed great potential for rapid microbial assessment. Biosensors are closer to wide-scale implementation followed by spectroscopic techniques and then by spectral imaging techniques and sensors designed to mimic human senses.
The influence of incorporation of post-distillation solid wastes of the aromatic plants (SWAP), oregano, rosemary, lemon balm, and spearmint into wheat breads at 1% and 2% levels on their physicochemical and sensorial properties, and antioxidant and volatile profiles were investigated. SWAP breads had darker crumbs and crust and greener crumbs compared to the control, but rather similar loaf specific volume and textural attributes (crust puncture test and crumb Texture Profile Analysis). Although the mold growth on bread crumb surface was not inhibited by SWAP presence, LC-DAD-MS revealed a large increase in terpenoids, like carnosic acid (all SWAP), carnosol (rosemary) and carvacrol (oregano), phenolic (rosmarinic and salvianolic) acids and flavonoids in bread with SWAP inclusion, leading to enhanced antioxidant capacity (ABST, DPPH and FRAP assays). The distinct aromatic plant flavors were detected in the fortified breads by trained assessors and confirmed by SPME-GC/MS volatile analysis, showing high levels of terpenoids in SWAP breads, like carvacrol (oregano), caryophyllene (rosemary and lemon balm), and carvone (spearmint), and rendering the 2% fortification unacceptable by consumers. Nevertheless, breads with 1% oregano or rosemary waste had similar control overall acceptability scores, indicating that SWAP can be a promising ingredient for developing antioxidant-enriched wheat breads.
The expansion of the seaweed aquaculture sector along with the rapid deterioration of these products escalates the importance of implementing rapid, real-time techniques for their quality assessment. Seaweed samples originating from Scotland and Ireland were stored under various temperature conditions for specific time intervals. Microbiological analysis was performed throughout storage to assess the total viable counts (TVC), while in parallel FT-IR spectroscopy, multispectral imaging (MSI) and electronic nose (e-nose) analyses were conducted. Machine learning models (partial least square regression (PLS-R)) were developed to assess any correlations between sensor and microbiological data. Microbial counts ranged from 1.8 to 9.5 log CFU/g, while the microbial growth rate was affected by origin, harvest year and storage temperature. The models developed using FT-IR data indicated a good prediction performance on the external test dataset. The model developed by combining data from both origins resulted in satisfactory prediction performance, exhibiting enhanced robustness from being origin unaware towards microbiological population prediction. The results of the model developed with the MSI data indicated a relatively good prediction performance on the external test dataset in spite of the high RMSE values, whereas while using e-nose data from both MI and SAMS, a poor prediction performance of the model was reported.