The foundation pit of a suspension bridge project in the Three Gorges Reservoir area is investigated in this paper. The pit is located under an unstable rock mass and landslide body; its base lithology is mudstone. The bridge foundation pit project mainly adopts blasting excavation to accelerate construction progress. However, as a hazardous technique to engineering safety, the explosion vibration easily causes deterioration of the surrounding strata, thereby inducing slope instability and rock mass collapse. Besides, three major challenges should be considered: complex terrain conditions, difficulties in the blasting excavation of anchors, and the extremely high risk of construction. Therefore, comprehensive risk control measures using the methods of hierarchical excavation and minimum charge blasting are put forward. After the measures were verified to be feasible through finite element simulation, it was successfully applied to actual construction. In addition, this paper proposes using fiber concrete to reinforce slope retaining walls, and simulates the reinforced effect based on the research above. The results indicate that the risk control scheme is reasonable, which not only ensures the construction process but also guarantees the stability of the slope and unstable rock body. At the same time, the slope is reinforced with fiber concrete, which effectively decreases the protection wall thickness. Finally, the article can provide a valuable reference for similar engineering projects around the world.

Focusing on the dilemma that the traditional lateral shear keys are ineffectual in limiting the displacement and repair of small-to-medium spanning highway bridges, this paper briefly describes the necessity of considering fiber-reinforced polymer concrete with the shear keys design, and studies the seismic performance of an alternative retainer that focuses on three functions of “limiting displacement”, “energy consumption”, and “alternative link”. In order to study the anti-seismic effectiveness under the seismic loads, four alternative retainer specimens with different sizes were designed. The quasi-static tests were carried out on four specimens, respectively. The seismic damage mode of the quasi-static alternative retainer was investigated. We examined the influence of the designed parameter of the alternative retainer on the anti-seismic effectiveness of the alternative retainer. Taking a two-span simply supported girder bridge, for example, the comparison between the seismic response of the bridge with retainers and without is analyzed based on a consideration of the sliding plate rubber bearings and the test results of the new retainers. The results show that the failure mode of the new alternative retainers is a two-stage process involving the alternative links: firstly shear failure and then the overall retainer damages, which is convenient to retrofit and reinforce post-earthquake. The thickness of the web of the alternative link, as a sensitive factor, influences the bearing capacity of the new retainers, yield displacement, ultimate displacement, ductility coefficient and overall energy consumption. The height of the alternative link will merely influence the ultimate bearing capacity, and transverse replacement of the main girder with the new alternative retainers is greatly reduced compared to without retainers, and the seismic response increase in the pier is gentle.