Global navigation satellite system (GNSS) refractometry enables automated and continuous in situ snow water equivalent (SWE) observations. Such accurate and reliable in situ data are needed for calibration and validation of remote sensing data and could enhance snow hydrological monitoring and modeling. In contrast to previous studies which relied on post-processing with the highly sophisticated Bernese GNSS processing software, the feasibility of in situ SWE determination in post-processing and (near) real time using the open-source GNSS processing software RTKLIB and GNSS refractometry based on the biased coordinate Up component is investigated here. Available GNSS observations from a fixed, high-end GNSS refractometry snow monitoring setup in the Swiss Alps are reprocessed for the season 2016/17 to investigate the applicability of RTKLIB in post-processing. A fixed, low-cost setup provides continuous SWE estimates in near real time at a low cost for the complete 2021/22 season. Additionally, a mobile, (near) real-time and low-cost setup was designed and evaluated in March 2020. The fixed and mobile multi-frequency GNSS setups demonstrate the feasibility of (near) real-time SWE estimation using GNSS refractometry. Compared to state-of-the-art manual SWE observations, a mean relative bias below 5% is achieved for (near) real-time and post-processed SWE estimation using RTKLIB.
Reliable in situ surface mass balance (SMB) estimates in polar regions are scarce due to limited spatial and temporal data availability. This study aims at deriving automated and continuous specific SMB time series for fast-moving parts of ice sheets and shelves (flow velocity > 10 m a−1) by developing a combined global navigation satellite system (GNSS) reflectometry and refractometry (GNSS-RR) method. In situ snow density, snow water equivalent (SWE), and snow deposition or erosion are estimated simultaneously as an average over an area of several square meters and independently on weather conditions. The combined GNSS-RR method is validated and investigated regarding its applicability to a moving, high-latitude ice shelf. A combined GNSS-RR system was therefore installed in November 2021 on the Ekström ice shelf (flow velocity ≈ 150 m a−1) in Dronning Maud Land, Antarctica. The reflected and refracted GNSS observations from the site are post-processed to obtain snow accumulation (deposition and erosion), SWE, and snow density estimates with a 15 min temporal resolution. The results of the first 16 months of data show a high level of agreement with manual and automated reference observations from the same site. Snow accumulation, SWE, and density are derived with uncertainties of around 9 cm, 40 kg m−2 a−1, and 72 kg m−3, respectively. This pilot study forms the basis for extending observational networks with GNSS-RR capabilities, particularly in polar regions. Regional climate models, local snow modeling, and extensive remote sensing data products will profit from calibration and validation based on such in situ time series, especially if many such sensors will be deployed over larger regional scales.
19 November 2021 in IEEE Transactions on Geoscience and Remote Sensing
A tower-based global navigation satellite system reflectometry (GNSS-R) experiment is set up in an Arctic wetland environment for investigating the possibility of monitoring wetland inundation and freeze/thaw (FT) dynamics which are additionally impacted by snow on the ground. Effects of inundation, snow cover, and soil FT state on observed GNSS-R signal-to-noise ratios (SNRs) are analyzed for horizontal (H) and vertical (V) polarizations. A simple classification approach is suggested to detect the inundated, frozen, or thawed soil state. A simple forward reflectivity model is formulated to evaluate the influence of snow cover, overlying frozen, or thawed soil, on the reflected GNSS signals. Reflectivity time series are simulated in H- and V-polarizations using in situ observations of the Arctic wetland site. The simulations are used to verify the tower-based observations, which show a significant impact of wet snow on reflectivity during melting conditions in spring. The observed SNR is strongly correlated with the Sentinel-1 backscatter coefficient. Generally, soil states detected by GNSS-R are in high agreement with ground truth soil states, especially for inundated and frozen soils. Wet snow conditions, however, complicate the correct timing estimation of soil thawing by inducing reflectivities of a similar order as thawing soil. It is recommended that GNSS-R land application models and retrieval algorithms consider snow cover effects to reduce false classification, especially in FT detection. Overall, the outcome of this study is relevant to the upcoming ESA HydroGNSS mission.
We developed a methodology for deriving automated and continuous specific surface mass balance time series for fast moving parts of ice sheets and shelves (>10m/a) by an accurate and simultaneous estimation of continuous in-situ snow density, snow water equivalent (SWE), and snow deposition and erosion, averaged over an area of several square meters and independent on weather conditions. Reliable in-situ surface mass balance estimates are scarce due to limited spatial and temporal data availability. While surface accumulation can be obtained in various ways, conversion to mass requires knowledge of the snow density, which is more difficult to obtain.A combined Global Navigation Satellite Systems reflectometry and refractometry (GNSS-RR) approach based on in-situ refracted and reflected GNSS signals is developed. The individual GNSS-RR methods have already been successfully applied on stationary grounds and seasonal snowpacks and are now combined and transferred to moving surfaces like ice sheets. We installed a combined GNSS-RR system in November 2021 on the fast moving (~150m/d), high latitude Ekström ice shelf in the vicinity of the Neumayer III station in Antarctica. Continuous snow accumulation reference data is provided by a laser distance sensor at the same test site and manual density observations. Refracted and reflected GNSS observations from site are post-processed for SWE, snow accumulation, and snow density estimation with a sub-daily temporal resolution. Preliminary results of the first year of data show a high level of agreement with reference observations, calculated from snow accumulation data collected by the laser distance sensor and linearly interpolated monthly snow density observations of the uppermost layer equivalent to the height of snow above the buried antenna.The deployed devices are geared towards prototype applications for reliable low-cost applications, which will allow large-scale retrieval of surface mass balance for general cryospheric applications, not only on ice sheets or shelves, but also sea ice. Regional climate models, snow modelling, and extensive remote sensing data products will profit from calibration and validation based on the derived field measurements, once such sensors can be deployed on larger scales.
Reliable in situ surface mass balance (SMB) estimates in polar regions are scarce due to limited spatial and temporal data availability. This study aims at deriving automated and continuous specific SMB time series for fast moving parts of ice sheets and shelves (flow velocity > 10 m a-1) by developing a combined Global Navigation Satellite Systems (GNSS) reflectometry and refractometry (GNSS-RR) method. In situ snow density, snow water equivalent (SWE), and snow deposition or erosion are estimated simultaneously as an average over an area of several square meters and independent on weather conditions. The combined GNSS-RR method is validated and evaluated regarding its applicability on a moving, high latitude ice shelf. A combined GNSS-RR system was therefore installed in November 2021 on the Ekström ice shelf (flow velocity≈150 m a-1) in Dronning Maud Land, Antarctica. Reflected and refracted GNSS observations from the site are post-processed to obtain snow accumulation (deposition and erosion), SWE, and snow density estimates with a 15 min temporal resolution. Results of the first 16 months of data show a high level of agreement with manual and automated reference observations from the same site. Snow accumulation is derived with an uncertainty of around 9 cm, SWE around 40 kg m−2 a−1, and density around 72 kg m−3. This pilot study forms the base for extending observational networks with GNSS-RR capabilities, in particular in polar regions. Regional climate models, local snow modelling, and extensive remote sensing data products will profit from calibration and validation based on such in situ time series, especially if multiples of such sensors will be deployed over larger regional scales.