Sr2TiO4 is a promising photocatalyst for antibiotic degradation in wastewater. The photocatalytic performance of pristine Sr2TiO4 is limited to its wide bandgap, especially under visible light. Doping is an effective strategy to enhance photocatalytic performance. In this work, Nb/N co-doped layered perovskite Sr2TiO4 (Sr2TiO4:N,Nb) with varying percentages (0–5 at%) of Nb were synthesized by sol-gel and calcination. Nb/N co-doping slightly expanded the unit cell of Sr2TiO4. Their photocatalytic performance towards antibiotic (tetracycline) was studied under visible light (λ > 420 nm). When Nb/(Nb + Ti) was 2 at%, Sr2TiO4:N,Nb(2%) shows optimal photocatalytic performance with the 99% degradation after 60 min visible light irradiation, which is higher than pristine Sr2TiO4 (40%). The enhancement in photocatalytic performance is attributed to improving light absorption, and photo-generated charges separation derived from Nb/N co-doping. Sr2TiO4:N,Nb(2%) shows good stability after five cycles photocatalytic degradation reaction. The capture experiments confirm that superoxide radical is the leading active species during the photocatalytic degradation process. Therefore, the Nb/N co-doping in this work could be used as an efficient strategy for perovskite-type semiconductor to realize visible light driving for wastewater treatment.
Cu2ZnSnS4 (CZTS) thin film photocatalytic water splitting for hydrogen production under visible light irradiation has been reported together with CZTS nanoparticles prepared by ultrasonic spray pyrolysis and hydrothermal method, respectively. CZTS thin film provided higher H2 production rate (68.68 μmol · g−1 · h−1), which was 32 times higher than that of CZTS nanoparticles (2.08 μmol · g−1 · h−1) without loading any noble metals. What’s more, photocatalytic activity of CZTS thin film remained 94% after 48 h which confirmed the good stability and reusability of CZTS thin film. CZTS thin film is a potential and durable candidate for photocatalysis.
6 December 2022 in Russian Journal of Physical Chemistry A
Due to its green and pollution-free characteristics, photoelectrochemical cathodic protection technology is favored by scientific researchers in the research of metal corrosion protection. The conduction band of SrTiO3 is 0.2 eV more negative than TiO2, which has more application potential. The n-type SrTiO3 films with different heat treatment temperatures were prepared by ultrasonic spray pyrolysis. XRD, SEM, UV–Vis DRS, PL, EIS, Mott–Schottky were used to characterize the phase structure, microscopic morpho-logy, light absorption properties, and carrier properties of the samples. Finally, using 304 stainless steel (304 SS) as the protected substrate, the photoelectrochemical cathodic protection performance of the SrTiO3 film was investigated. The results show that the SrTiO3 film heat-treated at 550°C has better light absorption performance, lower photo-generated carrier recombination rate, smaller photo-generated resistance and higher carriers density than samples at 500 and 600°C. The photoelectrochemical cathodic protection performance test results show that: simulated sunlight, the SrTiO3 film can negatively shift the corrosion potential of 304 stainless steel to –0.34 V in a 3.5 wt % NaCl solution, which is negatively shifted compared to the corrosion potential of 304 stainless steel of –0.18 V up to 160 mV. And four open and closed light cycle tests proved that the performance of the SrTiO3 film did not decrease.