Rizky Hidayatullah

Dr. Rizky Hidayatullah


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 September 2022 in Forests
Verified
Journal Article
Open access
PDF file
Effendi Tri BahtiarEffendi Tri Bahtiar
Effendi Tri Bahtiar
EMErizal . MAgr
Erizal . MAgr
DHDede Hermawan
Dede Hermawan
Naresworo NugrohoNaresworo Nugroho
Naresworo Nugroho
RHRizky Hidayatullah
Rizky Hidayatullah
The beam stability factor (CL) is applied in construction practices to adjust the reference bending design value (Fb) of sawn lumber to consider the lateral-torsional buckling. Bending tests were carried out on 272 specimens of four wood species, namely, red meranti (Shorea sp.), mahogany (Swietenia sp.), pine (Pinus sp.), and agathis (Agathis sp.), to analyze a simply supported beam subjected to concentrated loads at several points. The empirical CL value is a ratio of the modulus of rupture (SR) of a specimen to the average SR of the standard-size specimens. The non-linear regression estimated the Euler buckling coefficient for sawn lumber beam (KbE) in this study as 0.413, with 5% lower and 5% upper values of 0.338 and 0.488. Applying the 2.74 factor, which represents an approximately 5% lower exclusion value on the pure bending modulus of elasticity (Emin) and a factor of safety, the adjusted Euler buckling coefficient (KbE′) value for a timber beam was 1.13 (0.92–1.34), which is within the range approved by the NDS (KbE′ = 1.20). This study harmonizes the NDS design practices of CL computation with the empirical results. Because agathis has the lowest ductility (μ), most natural defects (smallest strength ratio, S), and highest E/SR ratio, the agathis beam did not twist during the bending test; instead, it failed before twisting could occur, indicating inelastic material failure. Meanwhile the other specimens (pinus, mahogany, and red meranti), which have smaller E/SR ratio, higher ductility, and less natural defects, tended to fail because of lesser beam stability. This phenomenon resulted in the CL curve of agathis being the highest among the others. The CL value is mathematically related to the beam slenderness ratio (RB) and the E/SR ratio. Because the strength ratio (S) and ductility ratio (μ) have significant inverse correlations with the E/SR ratio, they are correlated with the CL value. Applying the CL value to adjust the characteristic bending strength is safe and reliable, as less than 5% of the specimens’ SR data points lie below the curve of the adjusted characteristics values.