This paper reports the results of a novel study of microbial acclimatization for bioplastics anaerobic degradation and conversion into biogas. Three sequential anaerobic digestion (AD) runs were carried out to favour microbial acclimatization to two different bioplastics, starch-based (SBS) and polyactic-acid (PLA). AD of SBS and PLA bioplastics was favoured by the acclimatization of the inoculum to the substrate after each run of AD. SBS conversion into biogas increased by 52 % (from 94 to 143 NL kgVS-1) and it was correlated with the enhanced growth of starch degrading bacteria such as Hydrogenispora, Halocella and Haloplasma. PLA anaerobic degradation increased by 97 % (from 395 to 779 NLbiogas kgVS-1) and it was related to the acclimatization of known PLA-degraders such as Tepidimicrobium, Methanothermobacter and Tepidanaerobacter. Microbial acclimatization appears a suitable and low-cost strategy to enhance bioplastics circularity by promoting their anaerobic biodegradation and conversion into biogas.
Manure treatment to recover nutrients presents a great challenge to delocalize nutrients from overloaded areas to those needing such nutrients. To do this, approaches for the treatment of manure have been proposed, and currently, they are mostly under investigation before being upgraded to full scale. There are very few fully operating plants recovering nutrients and, therefore, very few data on which to base environmental and economic studies. In this work, a treatment plant carrying out full-scale membrane technology to treat manure to reduce its total volume and produce a nutrient-rich fraction, i.e., the concentrate, was studied. The concentrate fraction allowed the recovery of 46% of total N and 43% of total P. The high mineral N content, i.e., N-NH4/total-N > 91%, allowed matching the REcovered Nitrogen from manURE (RENURE) criteria proposed by the European Commission to allow the potential substitution of synthetic chemical fertilizers in vulnerable areas characterized by nutrient overloading. Life cycle assessment (LCA) performed by using full-scale data indicated that nutrient recovery by the process studied, when compared with the production of synthetic mineral fertilizers, had a lower impact for the 12 categories studied. LCA also suggested precautions which might reduce environmental impacts even more, i.e., covering the slurry to reduce NH3, N2O, and CH4 emissions and reducing energy consumption by promoting renewable production. The system studied presented a total cost of 4.3 € tons-1 of slurry treated, which is relatively low compared to other similar technologies.
Polyhydroxyalkanoates (PHAs) are the new frontier of bioplastic production; however, research is needed to develop and characterise efficient mixed microbial communities (MMCs) for their application with a multi-feedstock approach. Here, the performance and composition of six MMCs developed from the same inoculum on different feedstocks were investigated through Illumina sequencing to understand community development and identify possible redundancies in terms of genera and PHA metabolism. High PHA production efficiencies (>80% mg CODPHA mg-1 CODOA-consumed) were seen across all samples, but differences in the organic acids (OAs) composition led to different ratios of the monomers poly(3-hydroxybutyrate) (3HB) to poly(3-hydroxyvalerate) (3HV). Communities differed across all feedstocks, with enrichments in specific PHA-producing genera, but analysis of potential enzymatic activity identified a certain degree of functional redundancy, possibly leading to the general high efficiency seen in PHA production from all feedstocks. Leading PHAs producers across all feedstocks were identified in genera such as Thauera, Leadbetterella, Neomegalonema and Amaricoccus.