The coupling beam damper is a fundamental energy dissipation component in coupling shear wall structures that directly influences the performance of the shear wall. Here, we proposed a two-fold design method that can give better energy dissipation performance and hysteretic behavior to coupling beam dampers. First, we devised four in-plane yielding coupling beam dampers that have different opening types but the same amount of total materials. Then the geometry parameters of each opening type were optimized to yield the maximum hysteretic energy. The search for the optimal parameter set was realized by implementing the Kriging surrogate model which iterates randomly selected input shape parameters and the corresponding hysteretic energy calculated by the infinite element method. By comparing the maximum hysteretic energy in all four opening types, one type that had the highest hysteresis energy was selected as the optimized design. This optimized damper has the advantages of having a simple geometry and a high dissipation energy performance. The proposed method also provided a new framework for the design of in-plane coupling beam dampers.

Rod structure has been widely used in aerospace engineering and civil engineering. Nondestructive testing is a very important method applied to detect unseen flaws in structures, ultrasonic wave nondestructive testing has been used in many areas. Finite Element Method is one of the most widely used numerical methods but would have a high cost when doing simulation on ultrasonic wave due to the requirement of small time interval and element size. Wavelet based finite element method could improve the spatial resolution with fewer elements needed but still needs very small time interval. Laplace transform could easily convert the time domain into frequency and then inverse to time domain. This paper presents an innovative method combining Laplace transform and B-spline wavelet on interval (BSWI) finite element method, which could not only decrease the element number but also increase the time integration interval. Moreover, this innovative method is applied to simulate the ultrasonic wave propagation in 1D rod structure as well as used for nondestructive testing of damages in rod structures.

Leakage through microscale or nanoscale cracks is usually hard to observe, difficult to control, and causes significant economic loss. In the present research, the leakage in a pipe was evaluated by the virtual entropy generation (VEG) method. In virtual entropy generation method, the “measured entropy generation” is forced to follow the “experimental second law of thermodynamics”. Taking the leakage as the source virtual entropy generation, a new pipe leakage evaluation criterion was analytically derived, which indicates that the mass leakage rate should be smaller than the pressure drop rate inside a pipe. A numerical study based on computational fluid dynamics showed the existence of an unrealistic virtual entropy generation at a high mass leakage rate. Finally, the new criterion was used in the evaluation of leakage available in the literature. These results could be useful for leakage control or industry criteria design in the future.