Christophe Darnault

Dr. Christophe Darnault


Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 September 2017 in Journal of Nanoparticle Research
Verified
Journal Article
Closed access
PDF file
BHBritta M. J. Huibers
Britta M. J. Huibers
APAshley R. Pales
Ashley R. Pales
LBLingyun Bai
Lingyun Bai
CLChunyan Li
Chunyan Li
LMLinlin Mu
Linlin Mu
CDChristophe Darnault
Christophe Darnault

14 March 2022 in SN Applied Sciences
Verified
Journal Article
Open access
PDF file
CLChunyan Li
Chunyan Li
AHAsra Hassan
Asra Hassan
MPMarcell Palmai
Marcell Palmai
PSPreston Snee
Preston Snee
PBPhilippe C. Baveye
Philippe C. Baveye
CDChristophe Darnault
Christophe Darnault
Understanding the stability and aggregation of nanoparticles in aqueous milieu is critical for assessing their behavior in the natural and engineered environmental systems and establishing their threat to human and ecosystems health. In this study, the colloidal stability and aggregation kinetics of nanocrystal quantum dots (QDs) —CdSe/ZnS QDs—were thoroughly explored under a wide range of aqueous environmental conditions. The z-average hydrodynamic diameters (z-avg. HDs) and zeta potential (ξ potential) of CdSe/ZnS QDs were measured in monovalent electrolyte (NaCl) and divalent electrolyte (CaCl2) solutions in both the absence and presence of natural organic matter (NOM)—Suwannee River natural organic matter, SRNOM to assess the dynamic growth of these nanoaggregate-QD-complexes, and the evaluation of their colloidal stability. Results show that CaCl2 was more effective to destabilize the QDs compared to NaCl at similar concentrations. An increase in NaCl concentration from 0.01 to 3.5 M increased the z-avg. HD of QD aggregates from 61.4 nm to 107.2 nm. The aggregation rates of QDs increased from 0.007 to 0.042 nm·s−1 with an increase in ionic strength from 0.5 to 3.5 M NaCl solutions, respectively. In the presence of Na+ cations, the aggregation of QDs was limited as steric forces generated by the original surface coating of QDs prevailed. In the presence of CaCl2, the aggregation of QDs was observed at a low concentration of CaCl2 (0.0001 M) with a z-avg. HD of 74.2 nm that significantly increased when the CaCl2 was higher than 0.002 M. Larger sizes of QD aggregates were observed at each level of CaCl2 concentration in suspensions of 0.002–0.1 M, as the z-avg. HDs of QDs increased from 125.1 to 560.4 nm, respectively. In the case of CaCl2, an increase in aggregation rates occurred from 0.035 to 0.865 nm·s−1 with an increase in ionic strength from 0.0001 M to 0.004 M, respectively. With Ca2+ cations, the aggregation of QDs was enhanced due to the bridging effects from the formation of complexes between Ca2+ cations in solution and the carboxyl group located on the surface coating of QDs. In the presence of SRNOM, the aggregation of QDs was enhanced in both monovalent and divalent electrolyte solutions. The degree of aggregation formation between QDs through cation-NOM bridges was superior for Ca2+ cations compared to Na+ cations. The presence of SRNOM resulted in a small increase in the size of the QD aggregates for each of NaCl concentrations tested (i.e., 0.01 to 3.5 M, except 0.1 M), and induced a monodispersed and narrower size distribution of QDs suspended in the monovalent electrolyte NaCl concentrations. In the presence of SRNOM, the aggregation rates of QDs increased from 0.01 to 0.024 nm 1 with the increase of NaCl concentrations from 0.01 to 2 M, respectively. The presence of SRNOM in QDs suspended in divalent electrolyte CaCl2 solutions enhanced the aggregation of QDs, resulting in the increase of z-avg. HDs of QDs by approximately 19.3%, 42.1%, 13.8%, 1.5%, and 24.8%, at CaCl2 concentrations of 0.002, 0.003, 0.005, 0.01, and 0.1 M, respectively. In the case of CaCl2, an increase in aggregation rates occurred from 0.035 to 0.865 nm·s−1 with an increase in ionic strength from 0.0001 to 0.004 M, respectively. Our findings demonstrated the colloidal stability of QDs and cations-NOM-QD nanoparticle complexes under a broad spectrum of conditions encountered in the natural and engineered environment, indicating and the potential risks from these nanoparticles in terms of human and ecosystem health.

20 November 2014 in Journal of Soils and Sediments
Verified
Journal Article
Closed access
PDF file
BUBurcu Uyuşur
Burcu Uyuşur
CLChunyan Li
Chunyan Li
PBPhilippe Baveye
Philippe Baveye
CDChristophe Darnault
Christophe Darnault

24 April 2018 in Hydrology and Earth System Sciences
Verified
Journal Article
Open access
PDF file
APAshley R. Pales
Ashley R. Pales
BLBiting Li
Biting Li
HCHeather M. Clifford
Heather M. Clifford
SKShyla Kupis
Shyla Kupis
NENimisha Edayilam
Nimisha Edayilam
CDChristophe Darnault
Christophe Darnault
The vadose zone is a highly interactive heterogeneous system through which water enters the subsurface system by infiltration. This paper details the effects of simulated plant exudate and soil component solutions upon unstable flow patterns in a porous medium (ASTM silica sand; US Silica, Ottawa, IL, USA) through the use of two-dimensional tank light transmission method (LTM). The contact angle (θ) and surface tension (γ) of two simulated plant exudate solutions (i.e., oxalate and citrate) and two soil component solutions (i.e., tannic acid and Suwannee River natural organic matter, SRNOM) were analyzed to determine the liquid–gas and liquid–solid interface characteristics of each. To determine if the unstable flow formations were dependent on the type and concentration of the simulated plant exudates and soil components, the analysis of the effects of the simulated plant exudate and soil component solutions were compared to a control solution (Hoagland nutrient solution with 0.01 M NaCl). Fingering flow patterns, vertical and horizontal water saturation profiles, water saturation at the fingertips, finger dimensions and velocity, and number of fingers were obtained using the light transmission method. Significant differences in the interface properties indicated a decrease between the control and the plant exudate and soil component solutions tested; specifically, the control (θ = 64.5° and γ = 75.75 mN m−1) samples exhibited a higher contact angle and surface tension than the low concentration of citrate (θ = 52.6° and γ = 70.8 mN m−1). Wetting front instability and fingering flow phenomena were reported in all infiltration experiments. The results showed that the plant exudates and soil components influenced the soil infiltration as differences in finger geometries, velocities, and water saturation profiles were detected when compared to the control. Among the tested solutions and concentrations of soil components, the largest finger width (10.19 cm) was generated by the lowest tannic acid solution concentration (0.1 mg L−1), and the lowest finger width (6.00 cm) was induced by the highest SRNOM concentration (10 mg L−1). Similarly, for the plant exudate solutions, the largest finger width (8.36 cm) was generated by the lowest oxalate solution concentration (0.1 mg L−1), and the lowest finger width (6.63 cm) was induced by the lowest citrate concentration (0.1 mg L−1). The control solution produced fingers with average width of 8.30 cm. Additionally, the wettability of the medium for the citrate, oxalate, and SRNOM solutions increased with an increase in concentration. Our research demonstrates that the plant exudates and soil components which are biochemical compounds produced and released in soil are capable of influencing the process of infiltration in soils. The results of this research also indicate that soil wettability, expressed as cosθ1∕2, should be included in the scaling of the finger dimension, i.e., finger width, when using the Miller and Miller (1956) scaling theory for the scaling of flow in porous media.

15 June 2017 in Water
Verified
Journal Article
Open access
PDF file
ZPZhenyang Peng
Zhenyang Peng
CDChristophe Darnault
Christophe Darnault
FTFuqiang Tian
Fuqiang Tian
PBPhilippe Baveye
Philippe Baveye
HHHongchang Hu
Hongchang Hu
Surfactants released into the terrestrial environment in large amounts can potentially alter the physical, chemical and biological properties of soils, particularly the saturated hydraulic conductivity (Ks). Unfortunately findings regarding this process are quite limited. In this study, column tests were used to analyze the effects of Aerosol 22, a widely used anionic surfactant, on Ks of loamy sand and sandy loam soils. Solutions were injected into columns from the bottom with controlled pressure heads. Both the overall Ks of columns and the Ks of 6 layers at distances of 0–1 cm, 1–3 cm, 3–5 cm, 5–7 cm, 7–9 cm, and 9–10 cm from the bottom, were continuously monitored before and after the surfactant injections. Results showed that the overall Ks of all columns decreased after 2–4 pore volumes of the surfactant injections. However, stabilization and even increase at the beginning of the surfactant injection was also observed due to the different Ks variations in different layers. Specifically, a surfactant injection of 2–4 pore volumes continuously decreased the Ks of the 0–1 cm layers which yielded a Ks reduction of two orders of magnitude and dominated the Ks variations of the column. In contrast, an increase in the Ks of the 1–3 cm and 3–5 cm layers was more likely, while Ks variation of the 5–10 cm layers was less likely. We hypothetically attributed the Ks variations to the swelling of clay, the collapse of soil aggregates and subsequent particle displacements from surfactant adsorption, which caused pore clogging in the bottom 0–1 cm layer and higher porosities in the layers above. The adsorption of the surfactant aggregates and crystallization were also possibly thought to cause a pore clogging in the bottom layer thus decrease the surfactant concentration from the inlet, the severity of which affects these layers less at greater distances from the inlet. In view of the uncertainty showed by the experimental results, we also suggest to include more replicate columns in future studies, so as to increase the repeatability of the measurements.

18 November 2017 in Applied Nanoscience
Verified
Journal Article
Open access
PDF file
LBLingyun Bai
Lingyun Bai
CLChunyan Li
Chunyan Li
CKCaroline Korte
Caroline Korte
BHBritta M. J. Huibers
Britta M. J. Huibers
APAshley R. Pales
Ashley R. Pales
CDChristophe Darnault
Christophe Darnault
Any efficient exploitation of new petroleum reservoirs necessitates developing methods to mobilize the crude oils from such reservoirs. Here silicon dioxide nanoparticles (SiO2 NPs) were used to improve the efficiency of the chemical-enhanced oil recovery process that uses surfactant flooding. Specifically, SiO2 NPs (i.e., 0, 0.001, 0.005, 0.01, 0.05, and 0.1 wt%) and Tween®20, a nonionic surfactant, at 0, 0.5, and 2 critical micelle concentration (CMC) were varied to determine their effect on the stability of nanofluids and the interfacial tension (IFT) at the oil–aqueous interface for 5 wt% brine-surfactant-SiO2 nanofluid-oil systems for West Texas Intermediate light crude oil, Prudhoe Bay medium crude oil, and Lloydminster heavy crude oil. Our study demonstrates that SiO2 NPs may either decrease, increase the IFT of the brine-surfactant-oil systems, or exhibit no effects at all. For the brine-surfactant-oil systems, the constituents of the oil and aqueous substances affected the IFT behavior, with the nanoparticles causing a contrast in IFT trends according to the type of crude oil. For the light oil system (0.5 and 2 CMC Tween®20), the IFT increased as a function of SiO2 NP concentration, while a threshold concentration of SiO2 NPs was observed for the medium (0.5 and 2 CMC Tween®20) and heavy (2 CMC Tween®20) oil systems in terms of IFT trends. Concentrations below the SiO2 NP threshold concentration resulted in a decrease in IFT, and concentrations above this threshold resulted in an increase in IFT. The IFT decreased until the NP concentration reached a threshold concentration where synergetic effects between nonionic surfactants and SiO2 NPs are the opposite and result in antagonistic effects. Adsorption of both SiO2 NPs and surfactants at an interface caused a synergistic effect and an increased reduction in IFT. The effectiveness of the brine-surfactant-SiO2 nanofluids in decreasing the IFT between the oil-aqueous phase for the three tested crude oils were ranked as follows: (1) Prudhoe Bay > (2) Lloydminster > and (3) West Texas Intermediate. The level of asphaltenes and resins in these crude oil samples reflected these rankings. A decrease in the IFT also indicated the potential of the SiO2 NPs to decrease capillary pressure and induce the movement and recovery of oil in original water-wet reservoirs. Conversely, an increase in IFT indicated the potential of SiO2 NPs to increase capillary pressure and oil recovery in reservoirs subject to wettability reversal under water-wet conditions. Raspberry-like morphology particles were discovered in 5 wt% brine-surfactant-SiO2 nanofluid-oil systems. The development of raspberry-like particles material with high surface area, high salt stability, and high capability of interfaces alteration and therefore wettability changes offers a wide range of applications in the fields of applied nanoscience, environmental engineering, and petroleum engineering.