Due to the broad bandwidths, terahertz (THz)-waves offer the possibility for wireless transmission of high data rates. Especially, broadband wireless access over short ranges and fixed wireless links based on THz-waves are very promising. They can be incorporated as a bridge for optical networks or an alternative for the connection of wireless stations in difficult environments, to transmit next generation HDTV signals or for the broadband connection of servers in a data center, for instance. The frequency range between 300 and 900 GHz is very promising for these applications since the possible bandwidth is very high and first electronic circuits will become available on the market soon. However, contrary to wireless links in the lower GHz-bands, the free-space path-loss is quite high and the attenuation due to molecules in the air or water droplets can significantly decrease the transmittable data rates in this frequency range. Here the basic properties of THz-waves will be investigated and the maximum achievable data rates for fixed wireless THz-links will be derived. In order to keep the considerations as general as possible, the derivations are based on simple assumptions and equations. Additionally, conclusions for the applicability of THz-waves for fixed wireless links with distances up to 1 km will be given and the special requirements for these systems will be discussed. As we will show, high data rates can only be transmitted via these links if transmitter and receiver antennas with very high gains are used. This requires an adaptive control of mechanical fluctuations.

Optics InfoBase is the Optical Society's online library for flagship journals, partnered and copublished journals, and recent proceedings from OSA conferences.

High-resolution, wide-bandwidth optical spectrum analysis is essential to the measuring and monitoring of advanced optical, millimeter-wave, and terahertz communication systems, sensing applications and device characterization. One category of high-resolution spectrum analyzers reconstructs the power spectral density of a signal under test by scanning a Brillouin gain line across its spectral extent. In this work, we enhance both the resolution and the optical rejection ratio of such Brillouin-based spectrometers using a combination of two techniques. First, two Brillouin loss lines are superimposed upon a central Brillouin gain to reduce its bandwidth. Second, the vector attributes of stimulated Brillouin scattering amplification in standard, weakly birefringent fibers are used to change the signal state of polarization, and a judiciously aligned output polarizer discriminates between amplified and un-amplified spectral contents. A frequency resolution of 3 MHz, or eight orders of magnitude below the central optical frequency, is experimentally demonstrated. In addition, a weak spectral component is resolved in the presence of a strong adjacent signal, which is 30 dB stronger and detuned by only 60 MHz. The measurement method involves low-bandwidth direct detection, and does not require heterodyne beating. The measurement range of the proposed method is scalable to cover the C + L bands, depending on the tunable pump source. The accuracy of the measurements requires that the pump frequencies are well calibrated.

The interference between two spectral lines of the frequency comb of a fiber femtosecond laser is used to generate millimeter-wave and terahertz tones. The two lines are selected by stimulated Brillouin scattering (SBS) amplification. All other modes are strongly rejected based on polarization discrimination, using the polarization-pulling effect that is associated with SBS. The inherent high spectral quality of a femtosecond fiber laser comb allows generation of millimeter- and terahertz waves with linewidths below 1 Hz, and a phase noise of −105 dBc/Hz at 10 kHz offset. The generation, free-space transmission and detection of continuous waves at 1 THz are demonstrated as well. Lastly, the generated millimeter-wave carriers are modulated by 40 Gbit/s data. The entire system consists of a fiber laser and standard equipment of optical telecommunications. Besides metrology, spectroscopy and astronomy, the method can be utilized for the emergent field of wireless millimeter-wave and THz-communications at ultra-high data rates.

Optics InfoBase is the Optical Society's online library for flagship journals, partnered and copublished journals, and recent proceedings from OSA conferences.

We investigate the gain bandwidth of stimulated Brillouin scattering (SBS) in multistage systems. As we will show, the bandwidth is reduced significantly by the number of stages, which can increase the distortions in cascaded slow-light systems, for instance. However, other applications, which are limited by the minimum bandwidth achievable with SBS, can benefit from the reduced bandwidth. Since the peak value of the SBS gain spectrum is not reduced by this method, the reduced bandwidth can drastically enhance the performance of many different applications, such as the quasi-light storage (QLS). The minimum bandwidth of 10.3 MHz for a one-stage system was reduced down to 5.8 MHz for three stages. With this reduced bandwidth, we achieved a storage time advancement of the QLS method by 60%.