In the extreme conditions of high altitude, low temperature, low pressure and high speed, the aircraft engine has a strong tendency to extinguish and it is then difficult to start secondary ignition, which means that re-ignition of the aircraft engine faces great challenges. Additionally, the ability of the single-channel gliding arc (1-GA) in assisting the ignition under extreme conditions is weak. In this paper, to solve this problem, a multichannel gliding arcs (MGA) system is proposed, using the principle of multichannel discharge. Experiments on the electrical characteristics and ignition performance of MGA were conducted under atmospheric pressure in a swirl model combustor. The electrical characteristics of MGA were investigated under different air velocities. The ignition process of MGA was recorded by using a high-speed camera with CH * filter. Results show that the three-channel gliding arcs (3-GA) and five-channel gliding arcs (5-GA) generated more averaged power than the 1-GA under a constant air velocity. For example, the 3-GA and 5-GA generated 112.8% and 187.3% more averaged power than that of the 1-GA at 74.6 m s −1 , respectively. The arc shapes of gliding arcs with different channel numbers were different and the duration time of ‘breakdown-stretching-extinguishing’ of MGA shortened. Furthermore, compared with the 1-GA, the percentage of the lean ignition limit widening of the 3-GA and 5-GA can reach 13.5% and 20.9% respectively. The frequency of re-breakdown in the discharge process using different gliding arc channel numbers is different, which can continuously inject energy into the combustor and generate the ‘flame combination’ phenomenon producing a larger flame area. The ignition process of MGA can be divided into three stages: sliding stage, flame combination stage and flame stabilization stage.
15 October 2020 in Journal of Physics D: Applied Physics
Designing a plasma synthetic jet actuator (PSJA) with high efficiency and low driving voltage is a permanent and unchangeable pursuit for researchers. Based on the surface flashover phenomenon of semiconductors, a novel semiconductor enhanced PSJA (SEPSJA) is put forward. The electrical characteristics and jet performance of the SEPSJA are investigated based on electrical measurements and a high speed schlieren image system. The minimum driving voltage of the SEPSJA with a 6 mm electrode distance can be reduced to about 2.64 kV at 1 atm and kept fixed over a large range of air pressure. With the same input energy, the performance of the SEPSJA is better than the traditional PSJA with a short electrode distance restricted by high breakdown voltage. Owing to the long inter-electrode gap, the average discharge efficiency can be improved by 40%–50% compared with the PSJA. An increase of over 70% of the maximum jet velocity is validated by the schlieren image. The maximum shock wave velocity of the SEPSJA (545 m s −1 ) increased by about 24% more than that of the traditional PSJA (439 m s −1 ). It can be concluded that the SEPSJA is worthy to be further studied in flow control field.
21 December 2022 in IEEE Transactions on Plasma Science
In a scramjet engine, the viscosity of kerosene increases, the oxygen content decreases, the atomization evaporation rate and chemical reaction rate of kerosene decrease significantly, and the flame propagation speed decreases significantly under the condition of low total temperature, leading to the difficulty of ignition. Therefore, it is urgent to innovate the repeatable ignition method suitable for ramjet from the source. Gliding arc plasma has the advantages of both thermal equilibrium and nonequilibrium plasma. It can be used as a stable high-temperature heat source and chemical reaction source to strengthen the whole process from ignition to flame combustion, which has a critical application prospect in broadening the ignition boundary of scramjet engines at low total temperature and improving flame stability. In this article, a gliding arc plasma igniter is designed and developed. The research of gliding arc plasma ignition technology in scramjet combustor is carried out from two aspects of the discharge characteristics of gliding arc plasma igniter and kerosene cracking characteristics experiment. The results show that the average power of the gliding arc igniter in the air environment is higher than that in the nitrogen environment. With the increase of flow rate, the average power of the igniter increases first and then decreases. The maximum average power of the igniter with nitrogen is 193.56 W, and the maximum average power in the air environment is 323.49 W. The cracking products of kerosene are mainly hydrogen, methane, ethylene, acetylene, and other hydrocarbons below C3. The concentration of the product was positively correlated with the excitation voltage and channel length, and the concentration of hydrogen was the largest. The concentration of cracking products is higher in air, where hydrogen is three times higher than that in nitrogen. The main flow ignition of scramjet was successfully achieved under the condition of 2-Ma inlet velocity and 1000 K inlet temperature.