In the extreme conditions of high altitude, low temperature, low pressure and high speed, the aircraft engine has a strong tendency to extinguish and it is then difficult to start secondary ignition, which means that re-ignition of the aircraft engine faces great challenges. Additionally, the ability of the single-channel gliding arc (1-GA) in assisting the ignition under extreme conditions is weak. In this paper, to solve this problem, a multichannel gliding arcs (MGA) system is proposed, using the principle of multichannel discharge. Experiments on the electrical characteristics and ignition performance of MGA were conducted under atmospheric pressure in a swirl model combustor. The electrical characteristics of MGA were investigated under different air velocities. The ignition process of MGA was recorded by using a high-speed camera with CH * filter. Results show that the three-channel gliding arcs (3-GA) and five-channel gliding arcs (5-GA) generated more averaged power than the 1-GA under a constant air velocity. For example, the 3-GA and 5-GA generated 112.8% and 187.3% more averaged power than that of the 1-GA at 74.6 m s −1 , respectively. The arc shapes of gliding arcs with different channel numbers were different and the duration time of ‘breakdown-stretching-extinguishing’ of MGA shortened. Furthermore, compared with the 1-GA, the percentage of the lean ignition limit widening of the 3-GA and 5-GA can reach 13.5% and 20.9% respectively. The frequency of re-breakdown in the discharge process using different gliding arc channel numbers is different, which can continuously inject energy into the combustor and generate the ‘flame combination’ phenomenon producing a larger flame area. The ignition process of MGA can be divided into three stages: sliding stage, flame combination stage and flame stabilization stage.
Multichannel gliding arcs actuators were designed to enhance the non-premixed combustion of the kerosene (RP-3) and air mixture in a swirl combustor near lean blow-out limit. The instantaneous voltage and current of the multichannel gliding arcs and the 1kHz high-speed CH* chemiluminescence imaging of the combustion process were simultaneously measured to show the characteristics of the process assisted by the plasma. When reaching near lean blow-out limit in a flow rate of 225 SLPM, at the combustor inlet, the emission intensity and projected flame assisted by the multichannel gliding arcs remain the same with decreased fuel flow rates from 3 to 1 ml/min, which assisted by the single gliding arc decreases nevertheless. The flame structure under the influence of plasma actuators with various channel numbers evolves differently owing to the differences in plasma distributions.