Ammonium sulfate (AS) and ammonium nitrate (AN) are key components of urban fine particles. Both field and model studies showed that heterogeneous reactions of SO2, NO2, and NH3 on wet aerosols accelerated the haze formation in northern China. However, little is known on phase transitions of AS‐AN containing haze particles. Here hygroscopic properties of laboratory‐generated AS‐AN particles and individual particles collected during haze events in an urban site were investigated using an individual particle hygroscopicity system. AS‐AN particles showed a two‐stage deliquescence at mutual deliquescence relative humidity (MDRH) and full deliquescence relative humidity (DRH) and three physical states: solid before MDRH, solid‐aqueous between MDRH and DRH, and aqueous after DRH. During hydration, urban haze particles displayed a solid core and aqueous shell at RH = 60–80% and aqueous phase at RH > 80%. Most particles were in aqueous phase at RH > 50% during dehydration. Our results show that AS content in individual particles determines their DRH and AN content determines their MDRH. AN content increase can reduce MDRH, which indicates occurrence of aqueous shell at lower RH. The humidity‐dependent phase transitions of nitrate‐abundant urban particles are important to provide reactive surfaces of secondary aerosol formation in the polluted air.
27 January 2017 in Atmospheric Chemistry and Physics
Many studies have focused on the physicochemical properties of aerosol particles in unusually severe haze episodes in North China instead of the more frequent and less severe hazes. Consistent with this lack of attention, the morphology and mixing state of organic matter (OM) particles in the frequent light and moderate (L & M) hazes in winter in the North China Plain (NCP) have not been examined, even though OM dominates these fine particles. In the present work, morphology, mixing state, and size of organic aerosols in the L & M hazes were systematically characterized using transmission electron microscopy coupled with energy-dispersive X-ray spectroscopy, atomic force microscopy, and nanoscale secondary ion mass spectrometer, with the comparisons among an urban site (Jinan, S1), a mountain site (Mt. Tai, S2), and a background island site (Changdao, S3) in the same hazes. Based on their morphologies, the OM particles were divided into six different types: spherical (type 1), near-spherical (type 2), irregular (type 3), domelike (type 4), dispersed-OM (type 5), and OM-coating (type 6). In the three sampling sites, types 1–3 of OM particles were most abundant in the L & M hazes and most of them were internally mixed with non-OM particles. The abundant near-spherical OM particles with higher sphericity and lower aspect ratio indicate that these primary OM particles formed in the cooling process after polluted plumes were emitted from coal combustion and biomass burning. Based on the Si-O-C ratio in OM particles, we estimated that 71 % of type 1–3 OM particles were associated with coal combustion. Our result suggests that coal combustion in residential stoves was a widespread source from urban to rural areas in NCP. Average OM thickness which correlates with the age of the air masses in type 6 particles only slightly increased from S1 to S2 to S3, suggesting that the L & M hazes were usually dry (relative humidity < 60 %) with weak photochemistry and heterogeneous reactions between particles and gases. We conclude that the direct emissions from these coal stoves without any pollution controls in rural areas and in urban outskirts contribute large amounts of primary OM particles to the regional L & M hazes in North China.
Aerosol–cloud interactions remain a major source of uncertainty in climate forcing estimates. Few studies have been conducted to characterize the aerosol–cloud interactions in heavily polluted conditions worldwide. In this study, cloud residual and cloud interstitial particles were collected during cloud events under different pollution levels from 22 July to 1 August 2014 at Mt. Tai (1532 m above sea level) located in the North China Plain (NCP). A transmission electron microscope was used to investigate the morphology, size, and chemical composition of individual cloud residual and cloud interstitial particles, and to study mixing properties of different aerosol components in individual particles. Our results show that S-rich particles were predominant (78 %) during clean periods (PM 2.5< 15 µg m −3 ), but a large number of anthropogenic refractory particles (e.g., soot, fly ash, and metal) and their mixtures with S-rich particles (defined as “S-refractory”) were observed during polluted periods. Cloud droplets collected during polluted periods were found to become an extremely complicated mixture by scavenging abundant refractory particles. We found that 76 % of cloud residual particles were S-refractory particles and that 26 % of cloud residual particles contained two or more types of refractory particles. Soot-containing particles (i.e., S-soot and S-fly ash/metal-soot) were the most abundant (62 %) among cloud residual particles, followed by fly ash/metal-containing particles (i.e., S-fly ash/metal and S-fly ash/metal-soot, 37 %). These complicated cloud droplets have not been reported in clean continental or marine air before. Our findings provide an insight into the potential impacts on cloud radiative forcing from black carbon and metal catalyzed reactions of SO 2 in micro-cloud droplets containing soluble metals released from fly ash and metals over polluted air.