Agnese Innocenti

Dr. Agnese Innocenti

Department of Earth Sciences, University of Florence, Florence, Tuscany, Italy
orcid
PostDoctoral Researcher

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 September 2022 in Remote Sensing
Verified
Journal Article
Open access
PDF file
Yawar HussainYawar Hussain
Yawar Hussain
Romy SchlögelRomy Schlögel
Romy Schlögel
Agnese InnocentiAgnese Innocenti
Agnese Innocenti
Omar HamzaOmar Hamza
Omar Hamza
RIRoberto Iannucci
Roberto Iannucci
Hans-Balder HavenithHans-Balder Havenith
Hans-Balder Havenith
Landslides (LS) represent geomorphological processes that can induce changes over time in the physical, hydrogeological, and mechanical properties of the involved materials. For geohazard assessment, the variations of these properties might be detected by a wide range of non-intrusive techniques, which can sometimes be confusing due to their significant variation in accuracy, suitability, coverage area, logistics, timescale, cost, and integration potential; this paper reviews common geophysical methods (GM) categorized as Emitted Seismic and Ambient Noise based and proposes an integrated approach between them for improving landslide studies; this level of integration (among themselves) is an important step ahead of integrating geophysical data with remote sensing data. The aforementioned GMs help to construct a framework based on physical properties that may be linked with site characterization (e.g., a landslide and its subsurface channel geometry, recharge pathways, rock fragments, mass flow rate, etc.) and dynamics (e.g., quantification of the rheology, saturation, fracture process, toe erosion, mass flow rate, deformation marks and spatiotemporally dependent geogenic pore-water pressure feedback through a joint analysis of geophysical time series, displacement and hydrometeorological measurements from the ground, air and space). A review of the use of unmanned aerial vehicles (UAV) based photogrammetry for the investigation of landslides was also conducted to highlight the latest advancement and discuss the synergy between UAV and geophysical in four possible broader areas: (i) survey planning, (ii) LS investigation, (iii) LS dynamics and (iv) presentation of results in GIS environment. Additionally, endogenous source mechanisms lead to the appearance of deformation marks on the surface and provide ground for the integrated use of UAV and geophysical monitoring for landslide early warning systems. Further development in this area requires UAVs to adopt more multispectral and other advanced sensors where their data are integrated with the geophysical one as well as the climatic data to enable Artificial Intelligent based prediction of LS.

19 April 2023 in Remote Sensing
Verified
Journal Article
Open access
PDF file
Agnese InnocentiAgnese Innocenti
Agnese Innocenti
Ascanio RosiAscanio Rosi
Ascanio Rosi
Veronica TofaniVeronica Tofani
Veronica Tofani
Veronica PazziVeronica Pazzi
Veronica Pazzi
EGElisa Gargini
Elisa Gargini
Nicola CasagliNicola Casagli
Nicola Casagli
Performing a reliable stability analysis of a landslide slope requires a good understanding of the internal geometries and an accurate characterisation of the geotechnical parameters of the identified strata. Geotechnical models are commonly based on geomorphological data combined with direct and intrusive geotechnical investigations. However, the existence of numerous empirical correlations between seismic parameters (e.g., S-wave velocity) and geotechnical parameters in the literature has made it possible to investigate areas that are difficult to reach with direct instrumentation. These correlations are often overlooked even though they enable a reduction in investigation costs and time. By means of geophysical tests, it is in fact possible to estimate the N-SPT value and derive the friction angle from results obtained from environmental seismic noise measurements. Despite the empirical character and a certain level of uncertainty derived from the estimation of geotechnical parameters, these are particularly useful in the preliminary stages of an emergency, when straight data are not available and on all those soils where other direct in situ tests are not reliable. These correlations were successfully applied to the Theilly landslide (Western Alps, Italy), where the geotechnical model was obtained by integrating the results of a multi-parameter geophysical survey (H/V seismic noise and ground-penetrating radar) with stratigraphic and geomorphological observations, digital terrain model and field survey data. The analysis of the triggering conditions of the landslide was conducted by means of hydrological–geotechnical modelling, evaluating the behaviour of the slope under different rainfall scenarios and considering (or not) the stabilisation interventions present on the slope. The results of the filtration analyses for all events showed a top-down saturation mechanism, which led to the formation of a saturated face with a maximum thickness of 5 m. Stability analyses conducted for the same events showed the development of a shallow landslide in the first few metres of saturated soil. The modelling results are compatible with the actual evolution of the phenomenon and allow us to understand the triggering mechanism, providing models to support future interventions.

18 October 2022 in Landslides
Verified
Journal Article
Open access
PDF file
Agnese InnocentiAgnese Innocenti
Agnese Innocenti
VPVeronica Pazzi
Veronica Pazzi
LBLorenzo Borselli
Lorenzo Borselli
MNMassimiliano Nocentini
Massimiliano Nocentini
LLLuca Lombardi
Luca Lombardi
RFRiccardo Fanti
Riccardo Fanti
Back analysis is the most common method to study landslide movements after the event, and it allows us to understand how a landslide evolved along the slope. This paper presents the back-analysis of the Pomarico landslide (Basilicata, Italy) that occurred on January 25th, 2019, on the southwestern slope of the Pomarico hill. The landslide, of rotational clayey retrogressive type—planar sliding, evolved in different phases until it caused a paroxysmal movement in the early afternoon on January 29th, 2019. The landslide caused the collapse of a bulkhead (built at the end of the twentieth century) and of some buildings along the village’s main road. In this paper, a multi-layer back-analysis study is presented, based on the limit equilibrium model (LEM), applying the solution proposed by Morgenstern and Price in Geotechnique 15(1):79–93zh, (1965) and implemented in the freeware software SSAP 2010. The analysis allowed the reconstruction of the entire landslide evolution, using geotechnical parameters obtained from both laboratory and in situ tests, and data from the literature. The application of multilayer back-analysis made it possible to avoid the homogenisation of the layers, modelling the event according to the real conditions present on the slope. The use of the SSAP software made it possible to curb the problem related to the theoretical limitation of the shape of the rupture surfaces, by evaluating independently the friction angle locally and by discarding all those surfaces, which, due to this problem, presented a non-reliable factor of safety (FS) value. The modelling revealed a slope that is highly unstable as the height of the water table changes. The FS calculated under water table conditions close to ground level was less than 1 (FS = 0.98), simulating the first landslide movement (November 2018). The subsequent model reconstructed the critical surface responsible for the January 2019 movement and calculated the FS present on the slope (FS = 1.01). Eventually, the paroxysmal event on January 29th, 2019, was modelled, returning an FS of 0.83, and a sliding surface that sets below the bulkhead, causing its failure. Furthermore, the modelling of the slope in the presence of adequate retaining structures demonstrated the (non-) effectiveness of the retaining wall system represented by the bulkhead. The proposed method of analysis suggests further applications in similar complex multi-layer soil-structure interaction scenarios.

11 March 2024 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Open access
LCLorenzo Ciani
Lorenzo Ciani
Gabriele PatriziGabriele Patrizi
Gabriele Patrizi
Agnese InnocentiAgnese Innocenti
Agnese Innocenti
RFRiccardo Fanti
Riccardo Fanti
Veronica PazziVeronica Pazzi
Veronica Pazzi
To develop small-scale, shallow, and high-resolution electrical resistivity surveys (e.g., for archaeological or agricultural purposes) the available literature highlights few requirements in terms of distance between two adjacent electrodes or electrode’s length embedded in the soil. Nevertheless, there are no studies about the influence of the electrode’s diameter and/or the electrode’s diameter to electrode spacing ratio. Thus, this work proposes to investigate this ratio in relatively small-scale surveys (electrode spacing from 10 cm to 100 cm) to define an operational approach. The analysis has been conducted comparing the apparent resistivity data acquired by means of electrodes different in terms of diameter and materials. The apparent resistivity was chosen to avoid the introduction of further errors/approximations caused by the inversion procedure. Overall, six different types of electrodes have been employed and tested. The results of the data analysis emphasize the necessity of take into account the electrode diameter to electrode spacing ratio in the case of small-case Electrical Resistivity Tomography (ERT) surveys.

18 March 2024 in Irrigation Science
Verified
Journal Article
Open access
PDF file
Agnese InnocentiAgnese Innocenti
Agnese Innocenti
VPVeronica Pazzi
Veronica Pazzi
MNMarco Napoli
Marco Napoli
RFRiccardo Fanti
Riccardo Fanti
SOSimone Orlandini
Simone Orlandini
The characterization by means of geophysical techniques of agricultural soils subjected to continuous irrigation cycles makes it possible to study the heterogeneity of a soil and the preferential pathways of water flows without disturbing soil and plants. A better knowledge of soil heterogeneity enables optimal water resource management in terms of crop, yield, and sustainability. In this study, time-lapse monitoring using electrical resistivity tomographies (ERT) is proposed as a reliable and non-invasive technique to quantify the movement of water flows and thus the variation of soil water content during the irrigation process. ERT surveys have been conducted in melon-growing soils in southern Tuscany (Italy). Five survey campaigns have been carried out between June and August 2022, in which ERT data have been collected by taking measurements before ( T 0 ), during ( T 1 ), and after ( T 2 ) the irrigation phase. The interpretation of the ERT results provided information on the spatial and temporal distribution of water fluxes in the soil and root zone of melons during the irrigation phases. The investigation made it possible to identify the preferential pathways of infiltration of irrigation water, the points where water is absorbed by the roots, and the points where water follows a preferential pathway instead distributing itself entirely below the root growth zone. Thus, this research suggests that the ERT technique can be used to evaluate the efficiency of the irrigation system in order to achieve optimal management of the water resource, avoiding preferential flow paths that lead to less water availability for the plant.

9 October 2025 in Landslides
Verified
Journal Article
Open access
PDF file
Agnese InnocentiAgnese Innocenti
Agnese Innocenti
AMAnne-Sophie Mreyen
Anne-Sophie Mreyen
LCLéna Cauchie
Léna Cauchie
DCDavid Caterina
David Caterina
VDValmy Dorival
Valmy Dorival
VPVeronica Pazzi
Veronica Pazzi
The Pays de Herve region in East Belgium is characterised by widespread slope instability. Some of these Quaternary paleo-landslides are still active, showing subsidence phenomena that can be related to the presence of weak subsurface materials such as clays (locally topped by weathered chalk) overlying a discontinuous sand-silt layer. This study provides a detailed characterisation of three active landslides in the area, with a particular focus on the Manaihan landslide, which is the most active and has also caused damage to surrounding buildings. To investigate these landslides, an integrated geophysical approach was applied, combining electrical resistivity tomography, P-wave seismic refraction, multichannel analysis of surface waves, and microseismic ambient noise measurements (H/V analysis). Each method has intrinsic limitations, but their combined use allowed for a comprehensive analysis of the sliding surfaces. While the first three techniques provided detailed information on limited sectors of each landslide, the ambient noise measurements enabled the coverage of the entire landslide areas. This integrated approach, combining microseismic ambient noise frequency analysis, allowed for a detailed mapping of the Manaihan landslide’s subsurface and the creation of a 3D geological model of the site. The results align well with the geophysical imagery collected, allowing the precise identification of the landslide bases and enhancing the understanding of the subsurface structure in the Pays de Herve region.