Francesco Pignatelli

Mr. Francesco Pignatelli

Lund University, Lund, Sweden
orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 June 2023 in Combustion and Flame
Verified
Journal Article
Open access
FPFrancesco Pignatelli
Francesco Pignatelli
SDS. Derafshzan
S. Derafshzan
DSD. Sanned
D. Sanned
NPNikolaos Papafilippou
Nikolaos Papafilippou
RSRobert-Zoltan Szasz
Robert-Zoltan Szasz
ASA.A. Subash
A.A. Subash

HFHenrik Feuk
Henrik Feuk
FPFrancesco Pignatelli
Francesco Pignatelli
ASArman Subash
Arman Subash
RBRuike Bi
Ruike Bi
RSRobert-Zoltan Szasz
Robert-Zoltan Szasz
MRMattias Richter
Mattias Richter
The surface temperature of a burner nozzle using three different pilot hardware configurations was measured using lifetime phosphor thermometry with the ZnS:Ag phosphor in a gas turbine model combustor designed to mimic the Siemens DLE (Dry Low Emission) burner. The three pilot hardware configurations included a non-premixed pilot injection setup and two partially premixed pilot injections where one had a relatively higher degree of premixing. For each pilot hardware configuration, the combustor was operated with either methane or hydrogen-enriched methane (H2/CH4: 50/50 in volume %). The local heating from pilot flames was much more significant for hydrogen-enriched methane compared with pure methane due to the pilot flames being in general more closely attached to the pilot nozzles with hydrogen-enriched methane. For the methane fuel, the average surface temperature of the burner nozzle was approximately 40 K higher for the partially premixed pilot injection configuration with a lower degree of mixing as compared to the non-premixed pilot injection configuration. In contrast, with the hydrogen-enriched methane fuel, the differences in surface temperature between the different pilot injection hardware configurations were much smaller due to the close-to-nozzle frame structure.

16 December 2022 in Aerospace
Verified
Journal Article
Open access
PDF file
Arvid ÅkerblomArvid Åkerblom
Arvid Åkerblom
FPFrancesco Pignatelli
Francesco Pignatelli
CFChrister Fureby
Christer Fureby
The aviation sector is facing a massive change in terms of replacing the currently used fossil jet fuels (Jet A, JP5, etc.) with non-fossil jet fuels from sustainable feedstocks. This involves several challenges and, among them, we have the fundamental issue of current jet engines being developed for the existing fossil jet fuels. To facilitate such a transformation, we need to investigate the sensitivity of jet engines to other fuels, having a wider range of thermophysical specifications. The combustion process is particularly important and difficult to characterize with respect to fuel characteristics. In this study, we examine premixed and pre-vaporized combustion of dodecane, Jet A, and a synthetic test fuel, C1, based on the alcohol-to-jet (ATJ) certified pathway behind an equilateral bluff-body flameholder, spray combustion of Jet A and C1 in a laboratory combustor, and spray combustion of Jet A and C1 in a single-sector model of a helicopter engine by means of numerical simulations. A finite rate chemistry (FRC) large eddy simulation (LES) approach is adopted and used together with small comprehensive reaction mechanisms of around 300 reversible reactions. Comparison with experimental data is performed for the bluff-body flameholder and laboratory combustor configurations. Good agreement is generally observed, and small to marginal differences in combustion behavior are observed between the different fuels.