Underwater acoustic (UWA) communications systems suffer from a low signal-to-noise ratio (SNR) and a doubly selective channel, which are caused by many limitations, such as high propagation loss, slow propagation speed, and time-varying environmental factors. To overcome a low SNR, various diversity techniques are often adopted in UWA communications. However, such diversity can only be exploited with knowledge of the channel. Accordingly, channel estimation needs to be performed without obtaining the benefit of diversity. Moreover, accurate side information that can support a channel estimator (CE) is difficult to acquire at a low SNR under doubly selective channel. In this article, a novel CE based on an adaptive denoising is proposed for UWA orthogonal frequency-division multiplexing (OFDM) systems. The proposed method exploits two different types of pilot symbols. Channel impulse response (CIR) is estimated based on primary pilot symbols. By minimizing the squared error of the received secondary pilot symbols, a near-optimal denoising window is adaptively determined based on the channel length for the given CIR estimate. The proposed method does not require a priori information about channel statistics and SNR values. Analysis on the effect of denoising and the performance of the proposed denoising window estimator are also presented. Simulation and at-sea experiments verify that the proposed method has superior performance, compared with conventional CEs over diverse channel conditions. Complexity analysis shows that the proposed method is computationally efficient. Therefore, the proposed method is effective for real-time UWA OFDM systems under a harsh UWA channel with strong noise.
15 August 2019 in IEEE Wireless Communications Letters
Compressed sensing based channel state information (CSI) feedback schemes have been investigated as a feasible solution for massive antenna systems. Most of research works have focused on the measurement matrix design based on the sparsity obtained from spatially correlated channels. In this letter, we analyze the feasibility of a compressed CSI feedback based on the sparsity obtained from temporally correlated channels. The compressed feedback distortion and its rate loss in temporally correlated channels are analyzed as a function of the sparsity level and the number of transmit antennas, which are compared to those in uncorrelated channels. Based on the numerical analysis and simulation results, it is demonstrated that utilizing the sparsity obtained from temporally correlated channels is feasible for the compressed CSI feedback.
Given the ever-increasing interest in the Internet of Underwater Things (IoUT), various studies are ongoing to solve some of the practical problems affecting the development of underwater wireless communication. The main problems are related to the use of acoustic waves in a water medium, in which extremely high propagation loss and drastic channel fluctuation are common. On the basis of hands-on experience and measurements made in real underwater environments, the conventional Adaptive Modulation and Coding (AMC), which uses the high correlation between SNR (Signal to Noise Ratio) and BER (Bit Error Rate), might not be affordable in underwater environments because the normal correlation between SNR and BER almost disappears altogether. This work therefore collectively takes into account multiple quality factors of communication at the same time by creating, analysing and validating the machine learning model to predict the most adequate communication parameters to solve the problem. The dataset of underwater wireless communication used in the learning models was obtained from measurements made in a real underwater environment near the Gulf of Incheon, South Korea, using a practical testbed designed and implemented by the authors. The estimated network throughput based on the communications parameters predicted using the machine learning models was enhanced by up to 25% compared with the conventional handcraft method.
Harsh underwater channels and energy constraints are the two critical issues of underwater acoustic (UWA) communications. To achieve a high channel estimation performance under a severe underwater channel, sparse Bayesian learning (SBL)-based channel estimation was adopted for UWA orthogonal frequency division multiplexing (OFDM) systems. Accurate channel estimation can guarantee the successful reception of transmitted data and reduce retransmission occurrences, thereby, leading to energy-efficient communications. However, SBL-based algorithms have improved performances in iterative ways, which require high power consumption. In this paper, a fast SBL algorithm based on a weighted learning rule for hyperparameters is proposed for channel estimation in a UWA-OFDM system. It was shown via numerical analysis that the proposed weighted learning rule enables fast convergence and more accurate channel estimation simultaneously. Simulation results confirm that the proposed algorithm achieves higher accuracy in channel estimation with much fewer iteration numbers in comparison to conventional SBL-based methods for a time-varying UWA channel.
1 January 2017 in The Transactions of The Korean Institute of Electrical Engineers
Characteristic Comparison between PI and Hysteresis Voltage Control of High Voltage Unidirectional Inverter for Piezoelectric Load using FPGA Piezoelectric;Unidirectional inverter;Hysteresis control;Fly-back converter; In this paper, hysteresis voltage control method is proposed to an unidirectional inverter control for piezoelectric load. Piezoelectric load has electrically RC characteristic, and is driven by the inverter to control the output voltage waveform. When controling the output waveform by PI control, appropriate gains need to be selected. However, hysteresis control may minimize the output distortion because it has maximum proportional gain. In addition, Hysteresis control algorithm has simple structure to realize and the response is fast. Although the switching frequency of the inverter by hysteresis control varies, the switching frequency for the piezoelectric load is lower than that by PI control for equivalent performance. In particular, on implementing the algorithm using FPGA, the algorithm can be implemented in fewer pabrics and the processing time can be reduced. The superiority of the proposed hysteresis voltage control was proved for piezoelectric load through simulation and experiment.