Adjustable-speed drives with single-phase input require a power factor correction front-end, usually implemented by a boost converter, to reduce the current distortion from the uncontrolled rectifier; this stage is then followed by a three-phase inverter. Bulky electrolytic capacitors are used to limit the direct current voltage ripple resulting from the rectification of the single-phase input. This leads to increased system size and shorter lifetime. In this work, the usual boost front-end is exploited to actively control the DC link voltage ripple while limiting the input current distortion and, hence, the power factor, even if not reaching unity. However, Power Factor is greatly improved with respect to the uncontrolled rectifier alone. This approach permits one to reduce the required capacitance, allowing the substitution of the electrolytic capacitor with a long-life low-equivalent-series-resistance film one. A control targeting capacitor voltage level, ripple, and boost inductor peak current is presented, together with practical design models. The synergic control of the boost front-end and of the machine drive is presented as well. The resulting converter is tested with resistive load and permanent-magnet synchronous machine drive, highlighting the advantages and limits of the proposed solution.
10 June 2026 in IEEE Open Journal of Power Electronics
The physical size of modern power converters is constantly shrinking, while their power output is increasing. This requires innovative thermal management solutions to handle the power density growth. In this scenario, a real time estimate of the transistor junction temperatures avoids overheating issues, increasing the converter reliability. While a direct measurement is often not feasible, an indirect temperature estimate can be obtained with temperature-sensitive electric parameters (TSEPs). Adopting this technique usually requires an extensive individual characterization of each power device, involving laboratory equipment and thus limiting the method adoption. This article presents a complete solution to accurately characterize the chosen TSEP, adopting a fully in-circuit technique and a custom active gate driver (AGD). This method extracts the required characteristics from each power device, using only the hardware resources of the power converter. The proposed procedure manages the entire calibration process, dealing with device heating, measurement, data collection and synthesis of the temperature estimation model. The authors aim to make the proposed method suitable for a production environment, boosting the adoption of TSEP-based techniques in commercial converters. In this article the proposed procedure is leveraged to characterize and use the on-state resistance TSEP for online estimation in discrete silicon-carbide MOSFETs, although its applicability to other TSEPs and devices is also discussed. Finally, extensive experimental testing is conducted to evaluate the method effectiveness.