Mimoun Zazoui

Prof. Mimoun Zazoui

University of Hassan II Casablanca, Casablanca, Casablanca-Settat, Morocco
orcid

Research Focus & Metrics

Academic Career Length

38Years (1989-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 April 2002 in Semiconductor Science and Technology
Verified
Journal Article
Closed access
JBJ C Bourgoin
J C Bourgoin
MZMimoun Zazoui
Mimoun Zazoui

1 May 2003 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
MZMimoun Zazoui
Mimoun Zazoui
MMM. Mbarki
M. Mbarki
AAA. Zin Aldin
A. Zin Aldin
JBJ. C. Bourgoin
J. C. Bourgoin
OGO. Gilard
O. Gilard
GSG. Strobl
G. Strobl
We demonstrate how, using electroluminescence, the parameters characterizing the recombination center induced by irradiation in a solar cell can be measured. Because electroluminescence is able to provide information on an individual cell in a multijunction (MJ) cell device, independently of the others, we apply this technique to measure these parameters in InGaP/GaAs/Ge MJ cells. We then calculate the variations of the open-circuit voltage and short-circuit current of such cells versus fluence. The results are compared with experimental data obtained for 1 MeV electron irradiations.

1 June 1993 in Journal of Applied Physics
Verified
Journal Article
Closed access
MZM. A. Zaidi
M. A. Zaidi
MZMimoun Zazoui
Mimoun Zazoui
JBJ. C. Bourgoin
J. C. Bourgoin
We present a characterization of the defects created by electron irradiation at room temperature in n-type GaInP. Four electron traps, labeled E1–E4, and no hole traps have been detected using deep level transient spectroscopy in the temperature range 4–400 K. The corresponding energy levels and barriers associated with electron capture have been measured. The introduction rates, ranging from 4×10−3 to 0.4 cm−1, indicate that these defects are probably not primary defects but complexes resulting from the interaction of these primary defects between themselves or with impurities. This is not surprising, owing to the fact that defect annealing takes place below 300 K in InP.

1 July 1993 in Journal of Applied Physics
Verified
Journal Article
Closed access
JKJ. Krynicki
J. Krynicki
MZM. A. Zaidi
M. A. Zaidi
MZMimoun Zazoui
Mimoun Zazoui
JBJ. C. Bourgoin
J. C. Bourgoin
MDM. DiForte-Poisson
M. DiForte-Poisson
HBH. Blanck
H. Blanck
We have characterized by capacitance-voltage and deep level transient spectroscopy measurements the only defect detected in Si-doped GaInP layers. This defect exhibits an ionization energy of 0.435 eV but is located only at ∼20 meV below the bottom of the conduction band. All its characteristics, i.e., energy level, apparent capture barrier, ionization energy, can be understood if the defect is a donor associated DX center. Its cross section for electron and hole capture have been measured. The effect of an electric field on the ionization energy confirms that the defect is indeed shallow and a donor.

10 June 2002 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
MZMimoun Zazoui
Mimoun Zazoui
JBJ. C. Bourgoin
J. C. Bourgoin
We propose the use of electroluminescence to measure irradiation-induced degradation of multijunction photovoltaic cells in order to probe the degradation of each individual junction. We illustrate the technique by studying the decrease of the luminescence of GaInP, GaAs and Ge junctions of a triple-junction solar cell produced by 1 MeV electrons for fluences corresponding to space conditions.

13 September 2022 in Nanomaterials
Verified
Journal Article
Open access
PDF file
HLHind LAMKAOUANE
Hind LAMKAOUANE
HFHajar Ftouhi
Hajar Ftouhi
MRMireille Richard-Plouet
Mireille Richard-Plouet
NGNicolas Gautier
Nicolas Gautier
SNSTEPHANT NICOLAS
STEPHANT NICOLAS
Guy LouarnGuy Louarn
Guy Louarn
In the present study, MoO3:MoS2 hybrid thin layers have been synthesized through partial oxidation of MoS2. We have demonstrated that the reaction requires darkness conditions to decrease the oxidation rate, thus obtaining the hybrid, MoO3:MoS2. A simple liquid-phase exfoliation (LPE) is carried out to achieve homogenous MoS2 nanoflakes and high reproducibility of the results after MoS2 oxidation. XPS analyses reveal the presence of MoO3, MoS2, and MoOxSy in the hybrid layer. These results are also confirmed by X-ray diffraction and high-resolution TEM. Optical absorbance reveals that the absorption peaks of the MoO3:MoS2 hybrid are slightly redshifted with the appearance of absorption peaks in the near-infrared region due to the defects created after the oxidation reaction. The composition and atomic percentages of each component in the hybrid layer as a function of reaction time have also been reported to give perspective guides for improving electronic and optoelectronic devices based on 2D-MoS2.