The equiatomic CoCrFeNiMn alloy prepared by mechanical alloying and spark plasma sintering underwent partial substitution of Mn by Al (5, 10 and 15 at.%) to determine its influence on mechanical properties and thermal stability. It was discovered that the higher the Al content, the higher the volume fraction of the hard phase with primitive cubic (PC) crystallographic lattice, which increases the hardness and strength of the alloys. The most promising mechanical properties have been achieved in the CoCrFeNiMn5Al15 alloy reaching the compressive yield strength (CYS) of 2135 ± 21 MPa and the ultimate compressive strength (UCS) of 2496 ± 21 MPa. All the prepared alloys showed good thermal stability as they maintained or only slightly reduced their initial hardness during the 100 h annealing at 800 °C. Furthermore, the higher the Al content, the higher the resistance against high-temperature oxidation. The oxidic layer changed its composition from Mn-oxides (CoCrFeNiMn15Al15 alloy) to Al-based oxides with exceptional protective properties.

High-entropy alloys are known to possed good mechanical properties which are usually related to the preparation technique. In this work, the CoCrFeNiMnXAl20-X (X=5, 10, 15) alloys were prepared by a combination of mechanical alloying (MA) and ...

Three mechanically alloyed (MA) and spark plasma sintered (SPS) CoCrFeNiNbX (X = 5, 20, and 35 at.%) alloys with an addition of 5 at.% of SiC were investigated. The face-centered cubic (FCC) high-entropy solid solution, NbC carbides, and hexagonal Laves phase already developed during MA. In addition, the SPS compacting led to the formation of oxide particles in all alloys, and the Cr₇C₃ carbides in the Nb5 alloy. The fraction of the FCC solid solution decreased with increasing Nb concentration at the expense of the NbC carbide and the Laves phase. Long-term annealing at 800 °C led to the disappearance of the Cr₇C₃ carbide in the Nb5 alloy, and new oxides—Ni₆Nb₆O, Cr₂O₃, and CrNbO₄—were formed. At laboratory temperature, the Nb5 alloy, containing only the FCC matrix and carbide particles, was relatively strong and very ductile. At a higher Nb content (Nb20 and Nb35), the alloys became brittle. After annealing for 100 h at 800 °C, the Nb5 alloy conserved its plasticity and the Nb20 and Nb35 alloys maintained or even increased their brittleness. When tested at 800 °C, the Nb5 and Nb20 alloys deformed almost identically (CYS ~450 MPa, UTS ~500 MPa, plasticity ~18%), whereas the Nb35 alloy was much stronger (CYS of 1695 MPa, UCS of 1817 MPa) and preserved comparable plasticity.