Multiwalled carbon nanotubes (MWCNTs)/epoxy thin film nanocomposites were prepared using spin coating technique. The effects of process parameters such as sonication duration (5–35 min) and filler loadings (1-2 vol%) were studied using the design of experiment (DOE). Full factorial design was used to create the design matrix for the two factors with three-level experimentation, resulting in a total of 9 runs () of experimentation. Response surface methodology (RSM) combined with E.C. Harrington’s desirability function called desirability optimization methodology (DOM) was used to optimize the multiple properties (tensile strength, elastic modulus, elongation at break, thermal conductivity, and electrical conductivity) of MWCNTs/epoxy thin film composites. Based on response surface analysis, quadratic model was developed. Analysis of variance (ANOVA),-squared (-Sq), and normal plot of residuals were applied to determine the accuracy of the models. The range of lower and upper limits was determined in an overlaid contour plot. Desirability function was used to optimize the multiple responses of MWCNTs/epoxy thin film composites. A global solution of 12.88 min sonication and 1.67 vol% filler loadings was obtained to have maximum desired responses with composite desirability of 1.
3 October 2023 in Bulletin of Chemical Reaction Engineering & Catalysis
This work aimed to search optimal values for the properties of hydroxyapatite coated pure magnesium produced by cold spray deposition. Using fractional factorial design (2k-1), standoff distance, surface roughness and substrate heating temperature during cold spraying were selected as significant factors while number of sprays as insignificant factor. The responses chosen are coating thickness, hardness and elastic modulus of the coating. The analysis of the contour plots for thickness revealed that high thickness (>40 μm) was obtained when standoff distance is at 20-25 mm, surface roughness at 240-700 grit and substrate heating temperature at 350-550 °C. High nanohardness (>400 MPa) obtained when standoff distance is at 20-35 mm, surface roughness at 240-900grit and substrate heating temperature at 350-550 °C. High elastic modulus (>40 GPa) was obtained at 20-30 mm for standoff distance, 240-800 grit for surface roughness and 350-550 °C for substrate heating temperature. The contour plot of coating thickness, nanohardness and elastic modulus were overlaid to find the feasible region.
1 February 2014 in Journal of Alloys and Compounds
The growing global population and limitations in fish catch production have led to a surge in the demand for aquaculture. Contaminants of emerging concern (CEC) are frequently being detected at low levels in surface water. These CECs, which include previously unidentified or unregulated pollutants, pose potential risks to health and the environment, though their impacts are not yet fully understood. Extensive research studies have been proposed and undertaken to address the issue of aquaculture wastewater, aiming to minimize its impact and implement effective treatment methods. This review provides an analysis of various technologies used for treating aquaculture wastewater using advanced oxidation processes (AOPs) focusing on photocatalysis and ozonation. It examines their advantages and disadvantages, as well as their respective treatment efficacies, and discusses their potential applications in sustainable aquaculture practices complying with the Sustainable Development Goals of 1, 2, and 6 as well as being in line with the Environmental Social and Governance (ESG) framework.