Facile synthesis demonstrated formation of CuO/rGO composite for enhanced optical and electrical characteristics for sensing and photonic devices. CuO nanoparticles synthesized using sol-gel method and various rGO percentages (10%–30%) were loaded to form composite via ultra-sonic assisted technique. Structural study using XRD and TEM confirms the formation of CuO polyhedral nanoparticles with monoclinic structure showing deviations in the unit cell parameters, crystallite size, axis strain. These deviations cause transformation of polyhedral particles into rod shaped nanocomposites with embedded CuO single crystals with changed rGO. X-ray photoelectron spectroscopy showed varied elemental composition of CuO/rGO nanocomposites having Cu2+ chemical state. Optical measurements exhibit modified direct (1.54 eV–1.51 eV) and indirect bandgap (1.38 eV–1.31 eV) having higher absorption in Visible to NIR region for photovoltaic applications. Raman spectroscopy and FTIR confirms the presence of Raman active bands and functional groups corresponding to Cu-O. Electrical measurements shows decreased resistance with increased incorporation of rGO. The higher presence of oxygen sites and low resistance facilitate easy electron transport alongwith an optimum bandgap (1.51 eV) and higher absorption in Visible to NIR region showed possible utility of the grown nanoparticles and composites in gas/photo sensing and optoelectronic applications.
A ternary system of lead niobate–lead zirconate–lead titanate with composition xPN–yPZ–(x-y)PT where and , 0.25, and 0.35 known as PNZT has been prepared by conventional mixed oxide route at a temperature of 1100°C. The formation of the perovskite phase was established by X-ray diffraction analysis. The surface morphology studied by scanning electron microscopy shows the formation of fairly dense grains and elemental composition was confirmed by energy dispersive X-ray analysis. Dielectric properties like dielectric constant and dielectric loss ( and ) indicate poly-dispersive nature of the material. The temperature dependent dielectric constant () curve indicates relaxor behaviour with two dielectric anomalies. The poly-dispersive nature of the material was analysed by Cole-Cole plots. The activation energy follows the Arrhenius law and is found to decrease with increasing frequency for each composition. The frequency dependence of ac conductivity follows the universal power law. The ac conductivity analysis suggests that hopping of charge carriers among the localized sites is responsible for electrical conduction. The ferroelectric studies reveal that these ternary systems are soft ferroelectric.
Tin selenide (SnSe) has emerged as a surprising new p-type thermoelectric material with exceptionally low thermal conductivity, leading to impressive thermoelectric performance. However, the presence of thermally conducting & electrically insulating SnO2 at the grain boundaries of SnSe supresses its desirable thermoelectric properties. In this work we report temperature dependence of Seebeck coefficient for polycrystalline SnSe which exhibits an unusual reversible change in conduction from n- to p-type at ~ 565 K. The n-type conduction near room temperature is attributed to the Se deficiency as well as SnO2 present at grain boundaries. At high temperature formation of Sn vacancies leads to p-type conduction. The Zn doping at Sn site (Sn1−xZnxSe) establishes the usual p-type conduction in the entire temperature range along with the lowering of thermal conductivity, resulting in a figure-of-merit of ~ 0.15 at 700 K, which is nearly 275% higher than that for pristine SnSe. Graphical abstract