Despite extensive investigations over the past decade, the chemical basis of the extraordinary underwater adhesion properties of polydopamine (PDA) has remained not entirely understood. The bulk of evidence points to PDA wet adhesion as a complex process based on film deposition, and growth in which primary amine groups, besides catechol moieties, play a central role. However, the detailed interplay of chemical interactions underlying the dynamics of film formation has not yet been elucidated. Herein, we report the results of a series of experiments showing that coating formation from dopamine at pH 9.0 in carbonate buffer: (a) Requires high dopamine concentrations (>1 mM); (b) is due to species produced in the early stages of dopamine autoxidation; (c) is accelerated by equimolar amounts of periodate causing fast conversion to the o-quinone; and (d) is enhanced by the addition of hexamethylenediamine (HMDA) and other long chain aliphatic amines even at low dopamine concentrations (<1 mM). It is proposed that concentration-dependent PDA film formation reflects the competition between intermolecular amine-quinone condensation processes, leading to adhesive cross-linked oligomer structures, and the intramolecular cyclization route forming little adhesive 5,6-dihydroxyindole (DHI) units. Film growth would then be sustained by dopamine and other soluble species that can be adsorbed on the surface.
In the frame of a circular economy, the maximization of secondary raw-material recovery is necessary to increase the economic and environmental sustainability of landfill mining and reclamation activities. In this paper, the polyethylene-rich plastic fraction recovered from the reclamation of an abandoned industrial landfill (landfill-recovered plastic, LRP) has been characterized through spectroscopic, thermal, morphological, and mechanical analyses. Then, an economically viable valorization and recycling strategy was set up. The effectiveness of this strategy in the enhancement of LRP properties has been demonstrated through morphological and mechanical characterizations.
A high-resolution study of ubiquitin–polystyrene nanoparticle (PS-NP) interaction is reported. We also show the effects of PS-NPs on ubiquitination in HeLa cells.
Poly(vinyl alcohol) foams, containing different amounts of microfibrillated cellulose, were prepared through an eco-friendly procedure based on high-speed mixing and freeze-drying. The effect of filler amount on cell shape and regularity was studied by scanning electron microscopy (SEM) and the evolution of the microstructure was assessed through dynamic cryo-SEM. Fourier Transformed Infrared Analysis and Differential Scanning Calorimetry measurements revealed the presence of hydrogen bond interaction among cellulosic filler and the matrix. The modulus and compression deflection of neat PVA were significantly improved by increasing the amount of microfibrillated cellulose content with respect to foams realised with pulp cellulose fibers.
In this paper, a sustainable strategy to valorize and recycle heterogeneous polymer-based post-consumer waste is proposed. This strategy is based on a high-energy mechano-chemical treatment and has been applied to a polyolefin-rich fraction, coded as FIL/S, deriving from household plastic waste collection. This processing, performed in a planetary ball mill, allowed us to obtain fine grinding and, consequently, to induce an intimate mixing of the different polymer fractions and contaminants composing the FIL/S, as demonstrated by SEM analysis. As a result, an improvement in the deformability of the treated material was obtained, recording values for elongation at the break which were two and half times higher than the neat FIL/S. Finally, the addition of small amounts of organic peroxide during mechano-chemical treatment was tested, determining a more homogeneous morphology and a further improvement in mechanical parameters.