The rapid depletion of fossil fuel resources and environmental concerns has given awareness on generation of renewable energy resources. Among the various renewable resources, hybrid solar and wind energy seems to be promising solutions to provide reliable power supply with improved system efficiency and reduced storage requirements for stand-alone applications. This paper presents a feasibility assessment and optimum size of photovoltaic (PV) array, wind turbine and battery bank for a standalone hybrid Solar/Wind Power system (HSWPS) at remote telecom station of Nepal at Latitude (27°23'50") and Longitude (86°44'23") consisting a telecommunication load of Very Small Aperture Terminal (VSAT), Repeater station and Code Division Multiple Access Base Transceiver Station (CDMA 2C10 BTS). In any RES based system, the feasibility assessment is considered as the first step analysis. In this work, feasibility analysis is carried through hybrid optimization model for electric renewables (HOMER) and mathematical models were implemented in the MATLAB environment to perform the optimal configuration for a given load and a desired loss of power supply probability (LPSP) from a set of systems components with the lowest value of cost function defined in terms of reliability and levelized unit electricity cost (LUCE). The simulation results for the existing and the proposed models are compared. The simulation results shows that existing architecture consisting of 6.12 kW KC85T photovoltaic modules, 1kW H3.1 wind turbine and 1600 Ah GFM-800 battery bank have a 36.6% of unmet load during a year. On the other hand, the proposed system includes 1kW *2 H3.1 Wind turbine, 8.05 kW TSM-175DA01 photovoltaic modules and 1125 Ah T-105 battery bank with system reliability of 99.99% with a significant cost reduction as well as reliable energy production.

The study addresses the potential of using concentrated solar power plants (CSPs) as a sustainable alternative of clean energy generation in the Mediterranean region and, in particular, in its North Africa shore. This location presents attractive conditions for the installation of CSPs, in particular high solar irradiation, good manpower concentration, and proximity and availability of water resources for condenser cooling. Energetic, exergetic, and economic analyses were conducted taking into consideration a particular type of CSPs - the parabolic trough concentrated solar power plant, which incorporates the most proven technology and it is already used in Southern Europe (Spain). In addition, the study considered the impact of project financing and incentives on the cost of energy. The combination of higher values for performance and potentially lower levelized cost of electricity (LCE) for the North Africa Mediterranean Rim than the South of Spain region can yield a very favorable return for the invested capital. Tripoli compared to Almeria presented superior performance and potentially lower LCE values ($0.18/kWh versus $0.22/kWh). This is significant, even when it is taken into consideration the fact that the plant in Tripoli, despite a relatively modest capacity factor of 34%, has a large gross power output of 173,886 MWhe. In addition, the implementation at the Tripoli location of a plant similar to the Anadsol plant has a slight advantage (2–3%) in terms of overall efficiency.

Domestic refrigeration and freezing appliances can be used for electrical load shifting from peak to off-peak demand periods, thus allowing greater penetration of renewable energy sources (RES) and significantly contributing to the reduction of CO₂ emissions. The full realization of this potential can be achieved with the synergistic combination of smart grid (SG) technologies and the application of phase-change materials (PCMs). Being permanently online, these ubiquitous appliances are available for the most advanced strategies of demand-side load management (DSLM), including real-time demand response (DR) and direct load control (DLC). PCMs are a very cost-effective means of significantly augmenting their cold storage capacity and, hence, their load-shifting capabilities. Yet, currently, refrigerators and freezers equipped with PCMs for DSLM are still absent in the market and research works focusing on the synergy of these technologies are still scarce. Intended for a multidisciplinary audience, this broad-scoped review surveys the literature to evaluate the technological feasibility, economic viability and global impact of this combination. The state-of-the-art of SG-enabling technologies is investigated—e.g., smart meters, Internet-of-Things (IoT)—as well as current and future standards and norms. The literature on the use of PCMs for latent heat/cold storage (LHCS) is also reviewed.