The improper disposal of toxic and carcinogenic organic substances resulting from the manufacture of dyes, drugs and pesticides can contaminate aquatic environments and potable water resources and cause serious damage to animal and human health and to the ecosystem. In this sense, heterogeneous photocatalysis stand out as one effective and cost-effective water depollution technique. The use of metal oxide nanocomposites (MON), from the mixture of two or more oxides or between these oxides and other functional semiconductor materials, have gained increasing attention from researchers and industrial developers as a potential alternative to produce efficient and environmentally friendly photocatalysts for the remediation of water contamination by organic compounds. Thus, this work presents an updated review of the main advances in the use of metal oxide nanocomposites-based photocatalysts for decontamination of water polluted by these substances. A bibliometric analysis allowed to show the evolution of the importance of this research topic in the literature over the last decade. The results of the study also showed that hierarchical and heterogeneous nanostructures of metal oxides, as well as conducting polymers and carbon materials, currently stand out as the main materials for the synthesis of MON, with better photocatalysis performance in the degradation of dyes, pharmaceuticals and pesticides.

Impedance Spectroscopy (IS) is a general term for the technique referring to small-signal measurements of the linear electrical response of a domain of interest. This method is based on the analysis of the system’s electrical response to yield helpful information about its domain-dependent physicochemical properties (generally, the analysis is carried out in the frequency domain). Nowadays, there are many areas of application where IS can be used to evaluate or enhance the development of emerging products and processes. As a contribution to this field of research, this paper presents relevant theoretical–practical aspects of the interpretation and analysis of the electrical behavior of materials based on IS and IS modelling. The work starts by historically introducing IS and then goes through different domains of application of the technique, such as Materials Science and correlated areas. Afterwards, an introduction to IS usage for constructing equivalent electrical circuits is presented, aiming at modelling the materials’ electrical behavior, followed by examples from the literature that use the two possible circuit development approaches, the series and the parallel association of circuit elements. Lastly, the authors present a case study of their most recent efforts of a circuit model development of relative humidity (RH) sensors based on heterogeneous mixed metal oxide (MMO) nanostructures, used to understand and identify existing contributions to the overall electrical response of the sensors to moisture; in their case, the electrical response of the MMO sensors was modelled with a high level of superposition between the experimental and fitted data, using a parallel combination of circuit elements, which is an unconventional one.