The composition and antibacterial properties of copper particles synthesized by a very simple reduction method were studied. For the preparation of particles in knitted fabrics, copper(II) sulfate was used as a precursor and ascorbic acid as a reducing natural agent. X-ray diffraction analysis showed the crystalline nature of the obtained particles. The round or oval particles and their agglomerates in knitted fabrics consisted of copper with traces of copper(I) oxide—cuprite. The element maps and energy dispersive X-ray spectra showed a high content of copper in the samples. The samples of wool and cotton knitted fabrics with copper particles had excellent antibacterial activity against gram-positive Staphylococcus aureus (S. aureus) and gram-negative Escherichia coli (E. coli) bacterial strains. The maximum zones of inhibition were 19.3 mm for S. aureus and 18.3 mm for E. coli using wool knitted fabric and 14.7 mm and 15.3 mm using cotton knitted fabric, respectively. The obtained results showed that the modified wool and cotton fabrics are suitable for use as inserts in reusable masks due to their noticeable and long-term activity against pathogenic bacteria.
The development of eco-friendly, cost-effective, and naturally abundant electrode materials for supercapacitors is gaining critical importance in current energy storage research. This study focuses on the synthesis of tin sulfide (SnSx) films via the eco-friendly successive ionic layer adsorption and reaction (SILAR) method, employing varying quantities of L-ascorbic acid (0.8 and 1.0 g) as a reducing agent. Tin sulfide films were deposited on fluorine-doped tin oxide (FTO) glass substrates and subsequently annealed in an inert atmosphere at temperatures ranging from 200 to 400 °C, resulting in thin films of varying thicknesses (100–420 nm). The structural and compositional characteristics of the films were thoroughly analyzed using Raman spectroscopy to confirm the purity and spectroscopic signatures of the sulfides. Further characterization was performed to assess the films’ morphology (scanning electron microscopy, SEM), phase composition (X-ray diffraction, XRD), surface chemical states (X-ray photoelectron spectroscopy, XPS), optical properties (UV–Vis spectroscopy), and electrical properties (Hall measurements). The gathered data were then used to evaluate the potential of tin sulfide films as electrode materials in supercapacitors, highlighting their suitability for sustainable energy storage applications.
The acid etching mechanism of FTO film using zinc powders has been explored, and sulfuric and hydrochloric acid solutions of different concentrations were tested as etching agents. Compact and mesoporous films of titanium dioxide were prepared by spin-coating and doctor blade techniques on FTO glass. Tin sulfide films were formed through a successive ionic layer adsorption and reaction (SILAR) process using different numbers of deposition cycles, and TiO2/SnS nanocomposites were synthesized. The thin films and the prepared composites were characterized using X-ray diffraction, UV-Vis spectroscopy, scanning electron microscopy and energy-dispersive X-ray spectroscopy analyses. In this study, the principal characteristics of deposited tin sulfide films on two different types of TiO2 films are shown.
In this study, by varying the concentrations of the precursors used, copper sulfide films were deposited on FTO glass using the sequential ionic layer adsorption and reaction (SILAR) method and the following copper sulfide phases were detected: anilite, djurleite, chalcocite, and yarrowite. It was found that the films of copper sulfides are unevenly distributed, that the crystallinity of the films increases with increasing annealing temperature from 100 to 400 °C, and that the particles aggregate into agglomerates. The films formed were found to be dominated by copper sulfides, and the calculated molar ratio of copper to sulfur varied with the concentrations of the precursors used, ranging from 1.4 to 2.2. The values of the band gap energy were not significantly affected by the change in the concentrations of the precursors and the annealing temperature, varying between 1.0 and 1.5 and 1.95–2.15 eV.