Two different preparation methods, viz. incipient impregnation and mechanical mixing, have been used to prepare V-based oxygen carriers with different V loadings for chemical looping oxidative dehydrogenation of propane. The effect of the preparation method, V loading, and reaction temperature on the performance of these oxygen carriers have been measured and discussed. It was found that the VOx species can be well distributed on the support when the V loading is low (5 wt.% and 10 wt.%), but they may become aggregated at higher loadings. For oxygen carriers with a higher V loading, the oxygen transport capacity of the oxygen carrier, propane conversion and COx selectivities increase, while the propylene selectivity decreases. With a V-loading of 10 wt.%, the maximum propylene yield was achieved. The VOx species were better distributed over the support when applying the impregnation method; however, at higher V loadings the V-based oxygen carriers prepared by mechanical mixing showed a larger oxygen transport capacity. The oxygen carriers prepared by impregnation showed a better performance for the oxidative dehydrogenation of propane (ODHP) and re-oxidation reactions compared to oxygen carriers prepared by mechanical mixing. Higher reaction temperatures are favorable for the re-oxidation reaction, but unfavorable for the propylene production.
A fluorescence collecting unit was self-assembled in our lab. This unit in combination with a fluorescence spectrophotometer was applied to quantify fluorescent whitening agents (FWAs) in paper samples. The unit is small and portable, containing three light emitting diodes and a lens. The light emitting diodes were used as excitation light sources, and the emitted fluorescence entered the fluorescence spectrophotometer for signal detection after passing through the lens and a fiber. With high sensitivity, not only the total amount of FWAs in the paper samples could be determined but also the trace amount of FWAs migrated from paper to finger could also be obtained. The limit of detection was 0.12 mg m−2. Thirty practical paper notebook samples were analyzed for their FWA content before and after finger touch. For the purpose of comparison, the European standard method was also applied to determine the migration of FWA in these paper notebook samples. The correlation of the analytical results obtained by the present method with those obtained by the well-established European standard method was satisfactory.