Fabuer Ramón Valencia

Dr. Fabuer Ramón Valencia


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications

27 September 2022 in Polymers
Verified
Journal Article
Open access
PDF file
FVFabuer Ramón Valencia
Fabuer Ramón Valencia
GLGermán Castillo López
Germán Castillo López
JAJon Aurrekoetxea
Jon Aurrekoetxea
Alberto Lopez-ArraizaAlberto Lopez-Arraiza
Alberto Lopez-Arraiza
The present paper explores a new concept of a hybrid eco-composite by substituting the natural fibre plies with thin wood veneers. The new composite, named Fibre–Wood Laminate (FWL), is inspired by fibre–metal laminate materials. The studied FWL configuration consisted of a single thin pinewood veneer at each of the outer layers of a flax woven fabric reinforced bio-epoxy composite manufactured by infusion. Three-point bending results showed that wood veneer gives a highly anisotropic nature to the FWL. In the best case, with the grain of the wood at 0°, the stiffness and the strength increased by 28 and 41%, respectively, but reduced the strain-at-break by 27% compared to the flax fibre reinforced bio-epoxy (FFRB). The penetration and perforation energy thresholds and the peak force of the FWL obtained by falling weight impact tests were 32, 29, and 31% lower than those of the FFRB, respectively. This weakening was due to using single wood veneers, so the challenge for improving impact properties will be to explore thicker FWLs with different stacking sequences and orientations. The effect of immersing the FWL in seawater also showed considerable differences. The epoxy matrix filled the cellular structure of the wood veneers, creating a barrier effect and reducing the amount of water absorbed by the flax fibres.

28 March 2024 in Metals
Verified
Journal Article
Open access
PDF file
SGSteffen Gerke
Steffen Gerke
FVFabuer Ramón Valencia
Fabuer Ramón Valencia
Michael BrünigMichael Brünig
Michael Brünig
During the manufacturing and service of thin metal sheets, different stress states occur, often caused by non-proportional loading conditions. They can lead to localization of inelastic deformations as well as to damage and failure processes. In the present paper, a series of experiments with newly designed biaxially loaded specimens is presented to analyze the damage and failure behavior of thin ductile metal sheets under non-proportional load paths. Bands of holes with different orientation have been milled in critical regions of the specimens to localize stresses and strains. In compression tests, a special downholder is used to avoid buckling. During the loading processes, strain fields in critical regions of the specimens are monitored by digital image correlation technique. After the experiments, fracture surfaces are investigated by scanning electron microscopy showing different damage and fracture modes depending on the loading history. The experiments clearly demonstrate the efficiency of the thin specimens and the experimental program.