The layered perovskite, K2La2Ti3O10 was prepared by sol-gel method. Ion-exchange of Cu2+ was prepared to improve the photocatalytic activity of K2La2Ti3O10 for chlorobenzene degradation under simulated solar light irradiation. The original K2La2Ti3O10 and Cu2+/K2La2Ti3O10 were characterized by power X-ray diffraction, UV-visible diffuse reflectance spectroscopy, and specific surface area measurement. The XRD analysis shows that Cu2+ ions is incorporated in place of K+ ions and the grain growth is inhibited by ion-exchange. With the rise of calcination temperature, more interlayer Cu2+ was converted into new crystal phase CuO. The degradation ratio reaches 51.1% on Cu2+/K2La2Ti3O10 calcined at 500 °C in air, which is higher 16.9% than the original K2La2Ti3O10. It should be ascribed to the narrow interlayer distance, the formation of CuO, smaller grain size, and the high visible light absorption on the surface of Cu2+/K2La2Ti3O10 calcined at 500 °C. It is found that the exposure of CO2 could promote the photocatalytic activity of Cu2+/K2La2Ti3O10. It also suggests that CO2 is involved in the reduction to form benzaldehyde during decomposition of chlorobenzene.
1 November 2020 in Journal of Renewable and Sustainable Energy
A one-dimensional steady model for an annular thermoelectric generator (ATEG) is developed based on the thermoelectric power generation and thermal science in this paper. The influence of the Thomson effect and convection heat transfer between cold junction and ambient air on the performance of an ATEG is investigated. Closed-form solutions for power output and conversion efficiency of the ATEG are obtained, and they increase with the increasing values of the temperature at the hot junction and the convection heat transfer coefficient at the cold junction. The radiation heat transfer should not be neglected when the convection heat transfer coefficient is less than 100 . It is found that the Thomson effect has a negative impact on the power output and efficiency and should be considered for predicting the performance of an ATEG accurately. The height of thermoelectric legs should be taken into account in order to obtain the excellent performance of the ATEG. The presented model can be reduced to the model of the ATEG subjected to the constant temperatures at the hot and cold junctions when the convection heat transfer coefficient is large enough.